ML20215J951

Change Notice 001 to Rev 2 to Quality Instruction QI-070, Reinsp of Tubing Welds/Matls

ML20215J951
Person / Time
Site:	Comanche Peak
Issue date:	08/06/1986
From:	Patterson A, Zill R EVALUATION RESEARCH CORP.
To:
Shared Package
ML20215J430	List: ML20215J798 ML20215J803 ML20215J813 ML20215J818 ML20215J826 ML20215J830 ML20215J839 ML20215J844 ML20215J854 ML20215J868 ML20215J883 ML20215J902 ML20215J913 ML20215J931 ML20215J935 ML20215J948 ML20215J951 ML20215J956 ML20215J960 ML20215J965 ML20215J970 ML20215J975 ML20215J980 ML20215J988 ML20215J996 ML20215K005 ML20215K008 ML20215K012 ML20215K017 ML20215K026 ML20215K039 ML20215K043 ML20215K046 ML20215K055 ML20215K059 ML20215K077 ML20215K080 ML20215K084 ML20215K090 ML20215K093 ML20215K099 ML20215K104 ML20215K108 ML20215K110 ML20215K113 ML20215K117 ML20215K122 ML20215K124 ML20215K129 ML20215K134 ... further results
References
QI-070-01, QI-70-1, NUDOCS 8610270264
Download: ML20215J951 (2)

Text

. - . ___ _ _ _ _ _ _

" I UiiCONTROLLED COPY i CONTRO ?_'E S tC 3Y '

FOR li!F0i;MATION ONLY j CONTROL NO NRC-col '

EVALUATION RESEARCH CORPORATION l

COMANCHE PEAK RESPONSE TEAM QUALITY INSTRUCTION FOR ISSUE-SPECIFIC ACTION PLAN ISAP VII.c l

l CHANGE NOTICE 001 INSTRUCTION NO: QI-070 REVISION NO: 2 ISSUE DATE: 08/06/86 REINSPECTION OF TUBING WELDS / MATERIAL The QI identified above is hereby changed as shown on the attached page of this notice.

l Prepared by: AfMA Date 8~/~

l I I

l l

Approved by: I/3Wd -[b'- Date Issue Coordinator Approved by: Date: 90-Y[

On-SiteQARpsedtative Approved by: [3\ Dates b![, b QA/fCR&9iewTeamLe& der //

0610270264 061010 PDH ADOCK 0500044S A PDR l

1 - - .

T s.i '

s

, Ch ngs Notico 001 j QI-070 Rev. 2

1. Change Attribute 1.a Weld ID and Location to read as follows:

Verify that the weld identification and location are per the drawing and applicable design documents.

NOTE 1: No dimensional checks are required.

NOTE 2: When the weld identification is not physically obtainable (i.e., not marked, covered, illegible, etc.)

or when it does not agree with the isometric drawing, verification of this attribute shall be made by location only, and shall be noted as such in the Remarks column of the Checklist.

4

. /

i s

l .

i -

l l

2 L