ML20202J434

Change Notice 002 to Rev 1 to Quality Instruction QI-066, Reinsp of Equipment Supports

ML20202J434
Person / Time
Site:	Comanche Peak
Issue date:	04/03/1986
From:	Bajada E, Hansel J, Patterson A EVALUATION RESEARCH CORP.
To:
Shared Package
ML20202J051	List: ML20202J060 ML20202J066 ML20202J073 ML20202J086 ML20202J097 ML20202J103 ML20202J109 ML20202J118 ML20202J132 ML20202J135 ML20202J143 ML20202J149 ML20202J162 ML20202J169 ML20202J176 ML20202J179 ML20202J193 ML20202J199 ML20202J211 ML20202J218 ML20202J224 ML20202J236 ML20202J243 ML20202J250 ML20202J255 ML20202J282 ML20202J286 ML20202J294 ML20202J301 ML20202J306 ML20202J310 ML20202J316 ML20202J323 ML20202J331 ML20202J339 ML20202J344 ML20202J349 ML20202J356 ML20202J364 ML20202J372 ML20202J377 ML20202J383 ML20202J387 ML20202J393 ML20202J402 ML20202J407 ML20202J419 ML20202J424 ML20202J428 ML20202J434 ... further results
References
QI-066, QI-66, NUDOCS 8607170080
Download: ML20202J434 (2)

Text

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

t

! l . .

90NMxcE0CDPy CONTROL No.Q EVALUATION RESEARCH CORPORATION COMANCHE PEAK RESPONSE TEAM QUALITY INSTRUCTION FOR ISSUE-SPECIFIC ACTION PLAN VII.c CHANGE NOTICE 002 INSTRUCTION NO.

QI-066 REVISION: 1 ISSUE DATE: 04/03/86 e

,_ REINSPECTION OF EQUIPMENT SUPPORTS The QI identified above is hereby changed as shown on the attached page of this notice.

Prepared by: MJ._ T.ddu a Date: 1 kee.m %

l i

Approved by: N O# I' Y"*~ Date: 4-1-N Issue Coordinator Approved by: . b. h bc/4_ Date: Y .3 84 On-Site QA Representa e Approved by:

levi'ev Team L'eader Date: '/ 3

/ '

Id Q

8607170080 860711 PDR ADOCK 05000445 A PDR

- - - - - - - - - _ _ _ _ _ _ _ _ _ _ _ _ _ - . _ _ _ _ __ _ _ _ _ _u

i n . .

g .

, Chcngo Notica 002 g QI-066 Rev. 1 Change Paragraph 5.2 " Location and Orientation" from:

" Verify that the equipment support location and orientation is in accordance with the installatica drawings. Where no tolerance is given the dimensions on the installation drawings shall be plus or minus 12 inches. Measurements are not required to be taken to surveyor bench marks. They may be taken to wall surfaces, column faces or finished floor level."

to:

" Determine equipment support location and orientation from installation drawings or DCA's provided within the support package.

There is no accept / reject criteria associated with this item."

Change Paragraph 5.5.B " Materials" Add the following note:

" Note: A307 bolting and nuts have no identification markings which '

are readily recognizable. Where A307 material is specified it is acceptable when no marking exists."

Pi

'd G

U 2