ML20064F125

/03L-0 on 781025:B Train Penetration Room Filtration Sys Inoperable.Caused by Low Spring Tension on Filter Support Assembly

ML20064F125
Person / Time
Site:	Farley
Issue date:	11/22/1978
From:	Hairston W ALABAMA POWER CO.
To:
Shared Package
ML20064F123	List: ML20064F122 ML20064F125
References
LER-78-082-03L, LER-78-82-3L, NUDOCS 7811280272
Download: ML20064F125 (3)

Text

.

U. S. NUCLE AR REGUL ATORY COMHSSION t uc rOR$G6

• LICENSEE EVENT REPORT LONTact aLocx: l l l l l l l (PLE ASE PRINT OR TYPE ALL REQUIRED INFORMATIONI

> c@

[G lhA9 l t l LICENSEE J l }! CODE l F l 1 l@l 0 l 0 l - l 0 l 0 *.UVSE LICEASE l 0 ls 0 l 0 l- l 250 l 076 l@l 4 l1TYPE LICENSE 11JO11b7l1l@l l

CAT 58 l@

' ~ 14 15 CO*J'T 101il  %"%' i 1. l@l 0151010101314 61 oOCKET NUVJE R 68 l 63a l@l 1 1012 is 1718 l@l1 11 121217 EVENT DATg 74 75 REPORT OATE 80 18l 7 B C0 EVENT DESCRIPTION AND PROBABLE CONSEQUENCES h I

[O 121 10n 10/25/78 a review of FNP-1-STP-124 data indicated that the reauirements of T/S 4.7.8.1.b.2 (filter penetration) had not been met when the STP was performed in 1

[o l 31 1 j oTT] 1 September 1978. The B train penetration room filtration system was declared inoperable l

[5Til I at 1230 on 10/25/78. T/S 3.7.8.1 requires two independent penetration room filtration I l o 16 I l systems to be operable. T/S 3.7.8.1 action state r.ent recuirements were met. The B trait 1 1 c 17 ] l penetration reem filtration system was returned to an operable status at 1511 on I E l10/27/78. The A train was operable. Ilealth/ safety of the public were not affected. s0 I

Sys*fU CAusE CAUSE C OY P. VALVE sJ3OO E CO*?p3NENT CODE sv6 CODE sV8 CODE CO3E CODE l o i s i, 8

11: 1 s 1@ LE_JG LBJ @ I F 11 I t i r i t i n I@ 19I z l@ LzJ 9 TO tt 12 12 18 20 @

7 oCCUReE%CE REPORT REVislON E EORNT6 AL RE* CPT NO. CO3E TYPE No.

_EVENTvias

@ g(;gp fg,599 [ 71 si ;2 l-j 23 i 018121 24 26 1/l 2;

1013 l 28 29 W

30 1-1 31 10 1 32

_ 21 d' sOJRs S 9 i FORT 8. sVPPLt MAN FAC URER f ACT ON ON*L NT i Iz l@ l3621 @ 10101010140 LyJ@ Ly_lO LaJ@. I 44A I 2 l 21047l@

I34 x'@l cl@ 34 3: 33 44 42 43 cAUSE CESCRIPrlOS AND CO9REOTIVE ACTIOW h I

lilolIExcess penetration was caused bv low sprine tension on the filter annnove nearM y A proposed 9 y [The spring tension was adjusted and a satisfactory retest was performed.

g g 1 l Technical Specifiertion revision alicwing a maximum filter penetration of less than The revision was y g l1% was approved by the PORC and is awaiting approval of the NORB.

g g,g4; } submitted to clarify T/S requirements. go l

7 6 9 OTsER sT4Tus @Es[c"OSSN oiscovERy oEsCRiPr Os O32 l 's'rINIs* *,POwEa l

i li I 5 l [J;j@ l Il 0 l 0l@l NA l lB l@[" Review of surveillance test dTta 80 A!Tiviry CcSitNT LOCATION OF RELEASE RELE ASED of RELEASE l lil6l W@ W WOUNT NA OF ACTivlTV J4 l

45

@l NA g,j l

i 1 11  ?

e # 7Av0 M ii f . .,' ' . i. 4 TYPE l

[ i l 71 l 0 l 0 l 0j@l z l@Cis;P.PTION l NA ao

' ' ' ' u l PERsosNe't iNJu' dies I NuvsER oEsCRIPTION l

i a l01010l@l n n NA LO'3 OF OR D AMAGE To FACILITv TYPE DESCRIPTION I

I i I o I Lz_l@lto NA go 7 E 9

' NRC USE ONLY ,

w,uf IEscsiPrioNO lllllIIll1IlI5 2 bl NA l

"

• 5 Tf t 7 9'h ~~

" gn NAME OF PHEPARER

. O. Hairston, III PHON E : (205) 899-5156 2

.W ALABAMA PO'WER COMPANY JOSEPH M. FARLEY NUCLEAR PLANT DOCKET NO. 50-348 ATTACHMENT TO LER 78-082/03L-0 Facility: Joseph M. Farley Unit 1 Report Date: 11/22/78 Event Date: 10/25/78 Identification of Event A review of FNP-1-STP-124 data indicated that the Filter penetration for the B train of the penetration room filtration system was .07%

filter penetration versus the .05% filter penetration requirement of Regulatory Guide 1.52, Rev.1, July 7,1976, paragraph C.5.c.

Conditions Prior to Event The Unit was in Mode 1 operating at 100% steady state power.

Description of Event Surveillance test procedure FNP-1-STP-124, Penetration Room Filtra-i tion Performance Test, was performed during the period 9/18/78 through 9/22/78. The unit was shutdown (in Mode 5) for a mainten-ance outage at the time. The test results indicated that the filter penetration for the B train penetration room filtration system was .07% penetration (as measured by a DOP test) vs. the

.05% penetration specified in the surveillance test procedure acceptance criteria. Technical Specification 4.7.8.1.e requires that the filter bank efficiency be greater than 99%. The test engineer interpreted this to allow a filter bank penetration of less than 1%. On this basis, a temporary change to the FNP-1-STP-124 acceptance criteria was initiated to revise the acceptance criteria to reflect a 1% penetration limit. The test was completed, and signed off as being satisfactory on 9/23/78. The unit re-entered Mode 4 at 1507 on 10/3/78.

On 10/25/78, a review of the temporary change revealed an apparent conflict in requirements between the Technical Specification noted above and Technical Specification 4.7.8.1.b.2 which refers to the requirements of Regulatory Guide 1.52, Revision 1, July 1976, paragraph C.S.c. This paragraph specifies a maximum allowable i

filter penetration of .05% (as measured by a DOP test). Since this value had been exceeded, the B train penetration room filtration

system was declared inoperable at 1230 on 10/25/78. The unit was in Mode 1 operating at 100% steady state power. It was the intent of the plant staf f to request a clarification of the HEPA filter penetration requirements in order to determine the operability of the B train penetration room filtration system.

( --

s.

. 78-082/03L-0 At 2235 on 10/25/78 the unit tripped. A temporary change to Technical Specification 3.7.8.1 was requested and approved on 10/26/78 to allow the unit to be returned to power while the limiting condition

for operation (B train penetration room filtration system inoperable)

was in effect. The plant filter testing consultant was scheduled to be on-site on 10/27/78 to follow the corrective maintenance and retest.

The B train penetration room filtration system was repaired, satis-factorily retested, and returned to an operable status at 1511 on 10/27/78.

Designation of Apparent Cause The excess penetration was caused by low spring tension on the filter support assembly.

Analysis of Event Technical Specification 3.7.8.1 action statement requirements were met. The penetration room filtration system is only required during the recirculation phase after a LOCA. The A train penetration roca filtration system was operable.

The health and safety of the general public were not affected by this occurrence.

Effect on Plant This occurrence prevented an immediate return to power af ter the unit tripped on 10/25/78. A temporary change to Technical Specifi-cation 3.7.8.1 was required to permit a mode change while under the

limiting condition for operation.

i Corrective Action The spring tension was adjusted and a satisfactory retest of FNP-1-STP-124 (partial) was performed.

A proposed Technical Specification revision allowing a maximum filter penetration of <1% was approved by the PORC and is awaiting NORB approval.

Failure Data None i

4 i

W -me-Tg--- w --g.- --,--- - - -

,.--,9 - - - >,-g 4-- + -