Information Notice 1993-89, Potential Problems with BWR Level Instrumentation Backfill Modifications
UNITED STATES
NUCLEAR REGULATORY COMMISSION
OFFICE OF NUCLEAR REACTOR REGULATION
WASHINGTON, D.C. 20555 November 26, 1993 NRC INFORMATION NOTICE 93-89: POTENTIAL PROBLEMS WITH BWR LEVEL
INSTRUMENTATION BACKFILL MODIFICATIONS
Addressees
All holders of operating licenses or construction permits for boiling water
reactors (BWRs).
Purpose
The U.S. Nuclear Regulatory Commission (NRC) is issuing this information
notice to alert addressees to potential problems that have been identified by
licensees involving hardware modification to the reactor vessel water level
instrumentation system. It is expected that recipients will review the
information for applicability to their facilities and consider actions, as
appropriate, to avoid similar problems. However, suggestions contained in
this information notice are not NRC requirements; therefore, no specific
action or written response is required.
Description of Circumstances
NRC Bulletin (NRCB) 93-03, "Resolution of Issues Related to Reactor Vessel
Water Level Instrumentation in BWRs," issued on May 28, 1993, requested that
licensees implement hardware modifications necessary to ensure the level
instrumentation system design is of high functional reliability for long-term
operation. In response to this bulletin, all BWR licensees with the exception
of Big Rock Point, which does not use cold reference leg instrumentation, have
either implemented modifications or have committed to implement modifications.
The majority of these licensees have decided to install a reference leg
backfill system to supply a continuous flow of water from the control rod
drive (CRD) hydraulic system through the reference legs to preclude migration
of dissolved noncondensible gases down the legs. In August 1993, a potential
problem was found at the Susquehanna nuclear power plant during the design of
this backfill modification.
Discussion
It was postulated at Susquehanna that a manual isolation valve in one of the
reference legs (see Figure 1) could be closed by operator error. Closure of
this valve would result in pressurization of that reference leg to CRD system
pressure and erroneous indication of low reactor water level and high reactor
pressure on all instrumentation associated with that reference leg. The
transient resulting from pressurization of the most limiting reference leg
9311190454 KE-e 193-o 93 Ill
K.,_ IN 93-89 November 26, 1993 includes reactor scram and opening of all safety relief valves (SRVs) due to
the false high reactor pressure. The SRVs would remain open and depressurize
the reactor until the valves are closed by operator action, or actual reactor
pressure falls below approximately 446 kPa [50 psig] at which time the valves
can no longer stay open. Reactor depressurization and loss of inventory
through the SRVs, in combination with the false low water level signal on the
affected reference leg, would result in closure of the main steam isolation
valves, actuation of high-pressure and low-pressure emergency core cooling
system (ECCS) and containment isolation. Low-pressure ECCS injection would
commence after the low-pressure permissive is satisfied. This permissive
would be satisfied in this scenario, allowing the low pressure ECCS injection
valves to open, because only one of the pressure transmitters is affected and
the logic would still be satisfied. A single failure could defeat this logic, however, preventing all low-pressure ECCS Injection. The low-pressure
permissive can be bypassed in the control room to open the injection valves
for all four low pressure core spray (LPCS) pumps. The Susquehanna licensee
has informed the NRC that it has physically disabled the manual isolation
valves to prevent misoperation of these valves; in addition, the valves are
not readily accessible as they are located 6.1 meters [20 feet] above the
floor.
This event was recently analyzed for the LaSalle plant by Commonwealth Edison.
The analysis indicates that the low-pressure permissive for opening the low- pressure ECCS injection valve would be defeated for the LaSalle design due to
the false high pressure signal, thus preventing ECCS injection from the
affected division. If a single failure is assumed in the relay for the low- pressure permissive on the other division, no low-pressure ECCS injection
would be available. Because the induced plant transient is potentially so
severe, LaSalle has designed its backfill modification to make the injection
point for the backfill system on the reactor side of the manual isolation
valve and excess flow check valve, thereby precluding the potential for
pressurization of the reference leg through the backfill system.
Commonwealth Edison took a different design approach for its Dresden and
Quad Cities plants. The backfill system design for Dresden and Quad Cities
injects into the reference leg on the instrument rack side of the manual
isolation valve and excess flow check valve. Additional administrative
controls were developed to ensure that the isolation valve would not be
inadvertently closed. The licensee analyzed the inadvertent closure of the
manual isolation valve for the Dresden and Quad Cities plants and concluded
that, while multiple SRVs would open, the resultant plant transient could be
mitigated by appropriate operator actions. Without operator actions, the low- pressure ECCS would be available for event mitigation; however, a single
failure in the instrumentation system could defeat the low-pressure permissive
for opening the low-pressure ECCS Injection valves and result in no low- pressure ECCS being available for this transient. The licensee also
determined that this design presented an unreviewed safety question because it
would increase the probability of a previously analyzed accident, and
submitted an application to amend its license pursuant to 10 CFR 50.90. The
NRC is currently reviewing the licensee submittal.
IN 93-89 November 26, 1993 Other minor problems with the backfill system have been encountered when
installing the system and returning the instrumentation to service after
installation was complete. At the Perry plant, a problem occurred when the
licensee was in the process of venting one of the instrument lines following
the installation of the modification. The job plan directed the operation of
the wrong valve, and instead of opening the vent valve the technician opened
the isolation valve, allowing air into the reference leg. As a result, the
instrumentation associated with the high pressure core spray system (HPCS) was
inoperable until it was re-filled and vented. Similar events have occurred at
other plants due to procedural inadequacy or lack of attention to detail.
Related Generic Communications
- NRC Information Notice 92-54, "Level Instrumentation Inaccuracies Caused
by Rapid Depressurization," July 24, 1992.
- Generic Letter 92-04, "Resolution of the Issues Related to Reactor
Vessel Water Level Instrumentation in BWRs Pursuant to 10 CFR 50.54(f),"
August 19, 1992.
- NRC Information Notice 93-27, 'Level Instrumentation Inaccuracies
Observed During Normal Plant Depressurization," April 8, 1993.
- NRC Bulletin 93-03, Resolution of Issues Related to Reactor Vessel
Water Level Instrumentation in BWRs,' May 28, 1993.
This information notice requires no specific action or written response. If
you have any questions regarding the information in this notice, please
contact the technical contact listed below or the appropriate Office of
Nuclear Reactor Regulation (NRR) project manager.
Brian K. Grimes, Director
Division of Operating Reactor Support
Office of Nuclear Reactor Regulation
Technical contact: Amy Cubbage, NRR
(301) 504-2875 Attachments:
1. Simplified Sketch of Backfill Modification
2. List of Recently Issued NRC Information Notices
rfl
tO CONDENSATE POT
REACTOR VESSEL
(
DRYWELL
REACTOR BLDG
U
7 MANUAL
L ISOLATION
C EXCESS FLOW
QA BOUNDARY $ CHECK VALVE
CRD CHARGING
WATER HEADER
REFERENCE LEG
INSTRtUm
VARIABLE
LEG
RACK C
e0 (
FIGURE 1 - SIMPLIFIED SKETCH OF BACKFILL MODIFICATION
cI-
Ij3 ED
w,
A4...achment 2 IN 93-89 November 26, 1993 LIST OF RECENTLY ISSUED
NRC INFORMATION NOTICES
Information Date of
Notice No. Subject Issuance Issued to
93-88 Status of Motor-Operated 11/30/93 All holders of OLs or CPs
Valve Performance Pre- for nuclear power reactors.
diction Program by the
Electric Power Research
Institute
93-87 Fuse Problems with 11/04/93 All holders of OLs or CPs
Westinghouse 7300 for nuclear power reactors.
Printed Circuit Cards
93-86 Identification of Iso- 10/29/93 All holders of OLs or CPs
topes in the Production for test and research
and Shipment of Byproduct reactors.
Material at Non-power
Reactors
93-85 Problems with X-Relays 10/20/93 All holders of OLs or CPs
in DB- and DHB-Type for nuclear power reactors.
Circuit Breakers Manu- factured by Westinghouse
93-84 Determination of Westing- 10/20/93 All holders of OLs or CPs
house Reactor Coolant for pressurized water
Pump Seal Failure reactors (PWRs).
93-83 Potential Loss of Spent 10/07/93 All holders of OLs or CPs
Fuel Pool Cooling for boiling water reactors
Following A Loss of (BWRs).
Coolant Accident (LOCA)
93-82 Recent Fuel and Core 10/12/93 All holders of OLs or CPs
Performance Problems in for nuclear power reactors
Operating Reactors and all NRC-approved fuel
suppliers.
93-81 Implementation of 10/12/93 All holders of OLs or CPs
Engineering Expertise for nuclear power reactors.
on Shift
OL - Operating License
CP - Construction Permit
IN 93-89 a-> November 26, 1993 Other minor problems with the backfill system have been encountered when
installing the system and returning the instrumentation to service after
installation was complete. At the Perry plant, a problem occurred when the
licensee was in the process of venting one of the instrument lines following
the installation of the modification. The Job plan directed the operation of
the wrong valve, and instead of opening the vent valve the technician opened
the isolation valve, allowing air into the reference leg. As a result, the
instrumentation associated with the high pressure core spray system (HPCS) was
inoperable until it was re-filled and vented. Similar events have occurred at
other plants due to procedural inadequacy or lack of attention to detail.
Related Generic Communications
- NRC Information Notice 92-54, "Level Instrumentation Inaccuracies Caused
by Rapid Depressurization," July 24, 1992.
- Generic Letter 92-04, "Resolution of the Issues Related to Reactor
Vessel Water Level Instrumentation in BWRs Pursuant to 10 CFR 50.54(f),"
August 19, 1992.
- NRC Information Notice 93-27, 'Level Instrumentation Inaccuracies
Observed During Normal Plant Depressurization," April 8, 1993.
- NRC Bulletin 93-03, 'Resolution of Issues Related to Reactor Vessel
Water Level Instrumentation in BWRs," May 28, 1993.
This information notice requires no specific action or written response. If
you have any questions regarding the information in this notice, please
contact the technical contact listed below or the appropriate Office of
Nuclear Reactor Regulation (NRR) project manager.
orig /s/'d by BKGrimes
Brian K. Grimes, Director
Division of Operating Reactor Support
Office of Nuclear Reactor Regulation
Technical contact: Amy Cubbage, NRR
(301) 504-2875 Attachments:
1. Simplified Sketch of Backfill Modification
2. List of Recently Issued NRC Information Notices
- SEE PREVIOUS CONCURRENCE
SRXB:DSSA* OGCB:DORS* TECH ED.* SRXB:DSSA* SRXB:DSSA* D:DSSA* OGCB:DORS*
ACUBBAGE PWEN RSANDERS WLYON RJONES ATHADANI GMARCUS
1 11/16/93 11/15/93 11/16/93 11/18/93 11/20/93 11/23/93
11/2.493 DOCUMENT NAME: 93-89.IN
IN 93-xx
November xx, 1993 This information notice requires no specific action or written response. If
you have any questions regarding the information in this notice, please
contact the technical contact listed below or the appropriate Office of
Nuclear Reactor Regulation (NRR) project manager.
Brian K. Grimes, Director
Division of Operating Reactor Support
Office of Nuclear Reactor Regulation
Technical Contact:
Amy Cubbage, NRR
(301) 504-2875 Attachments:
1. Simplified Sketch of Backfill Modification
2. List of Recently Issued NRC Information Notices
- SEE PREVIOUS CONCURRENCE
SRXB:DSSA* OGCB:DORS* TECH ED.* SRXB:DSSA* SRXB:DSSA* D: DSSA* OGCB:DORS
ACUBBAGE PWEN RSANDERS WLYON RJONES ATHADANI GMARCUS At'i
11/15/93 11/16/93 11/15/93 11/16/93 11/18/93 11/20/93 11/23/93 D: DORS
BGRIMES
11/ /93 DOCUMENT NAME: BWRWTLVL.WEN
instrumentation associated with the high pressure core spray system (HPCS) was
inoperable until it was re-filled and vented. Similar events have occurred at
other plants due to procedural inadequacy or lack of attention to detail.
Related Generic Communications
- NRC Information Notice 92-54, "Level Instrumentation Inaccuracies Caused
by Rapid Depressurization," July 24, 1992.
- Generic Letter 92-04, "Resolution of the Issues Related to Reactor
Vessel Water Level Instrumentation in BWRs Pursuant to 10 CFR 50.54(f),"
August 19, 1992.
- NRC Information Notice 93-27, "Level Instrumentation Inaccuracies
Observed During Normal Plant Depressurization," April 8, 1993.
- NRC Bulletin 93-03, "Resolution of Issues Related to Reactor Vessel
Water Level Instrumentation in BWRs," May 28, 1993.
This information notice requires no specific action or written response. If
you have any questions regarding the information in this notice, please
contact the technical contact listed below or the appropriate Office of
Nuclear Reactor Regulation (NRR) project manager.
Brian K. Grimes, Director
Division of Operating Reactor Support
Office of Nuclear Reactor Regulation
Technical Contact:
Amy Cubbage, NRR
(301) 504-2875 Attachments:
1. Simplified Sketch of Backfill Modification
2. List of Recently Issued NRC Information Notices
EDITED BY: R. Sanders
DATED: 11/15/93 SRXB:DSSA* OGCB:DORS* SRXB:DSSA* SRXB:DSSA* D:DSSA OGCB:DORS D:DORS
ACUBBAGE PWEN WLYON RJONES ATHAqkNI GMARCUS BGRIMES
11/15/93 11/16/93 11/16/93 11/18/93 11/?V/93 11/ /93 11/ /93
- SEE PREVIOUS CONCURRENCE