ML062140100

Supplement to License Change Request S05-09; Request for Change to Technical Specifications Refueling Operations and Special Test Exceptions

ML062140100
Person / Time
Site:	Salem
Issue date:	07/20/2006
From:	Joyce T P Public Service Electric & Gas Co
To:	Document Control Desk, Office of Nuclear Reactor Regulation
References
LCR S05-09, LR-N06-0263
Download: ML062140100 (11)

Text

PSEG Nuclear LLC P.O. Box 236, Hancocks Bridge, New Jersey 08038-0236 JUL 2 0 2006 LR-N06-0263 0 PSEG LCR S05-09 Nuclear LLC United States Nuclear Regulatory Commission Document Control Desk Washington, DC 20555 SUPPLEMENT TO LICENSE CHANGE REQUEST S05-09: REQUEST FOR CHANGE TO TECHNICAL SPECIFICATIONS REFUELING OPERATIONS AND SPECIAL TEST EXCEPTIONS SALEM NUCLEAR GENERATING STATION, UNIT NOS. I AND 2 FACILITY OPERATING LICENSES DPR-70 AND DPR-75 DOCKET NOS. 50-272 AND 50-311

References:

(1) Letter from PSEG to NRC: "Request for Change to Technical Specifications, Refueling Operations and Special Test Exceptions, Salem Nuclear Generating Station, Units 1 and 2, Facility Operating Licenses DPR-70 and DPR-75, Docket Nos. 50-272 and 50-311", dated December 7, 2005 In accordance with the requirements of 10 CFR 50.90, PSEG Nuclear LLC (PSEG)previously submitted License Change Request (LCR) S05-09 to amend the Technical Specifications (TS) for Salem Generating Station Unit 1 and Unit 2 (Reference 1).Following additional review and discussion with the NRC Staff, PSEG proposes to modify the amendment request as discussed below. Pursuant to the requirements of 10 CFR 50.91 (b)(1), a copy of this request for amendment has been sent to the State of New Jersey.The original amendment request contained two changes: (1) deletion of the surveillance requirement to perform a channel functional test of the source range neutron flux monitor within 8 hours9.259259e-5 days <br />0.00222 hours <br />1.322751e-5 weeks <br />3.044e-6 months <br /> prior to the initial start of core alterations, and (2) elimination of the surveillance requirement to subject each intermediate and power range channel to a channel functional test within 12 hours1.388889e-4 days <br />0.00333 hours <br />1.984127e-5 weeks <br />4.566e-6 months <br /> prior to initiating physics tests. These changes were proposed to eliminate extraneous and unnecessary performance of the surveillance requirements, consistent with TSTF 108, "Eliminate the 12 hour1.388889e-4 days <br />0.00333 hours <br />1.984127e-5 weeks <br />4.566e-6 months <br /> Channel Operational Test (COT) on Power Range and Intermediate Range Channels for Physics Test Exceptions," and NUREG-1431, "Standard Technical Specifications, Westinghouse Plants." Discussion with the NRC Staff identified that, while the proposed changes submitted were consistent with the TSTF and NUREG, the submitted changes were not comprehensive in alignment with the NUREG. Specifically, the required frequencies of the Channel Functional Testing that would continue to be required for the Intermediate Range, Source Range, and Power Range Monitors were not consistent with the NUREG. These differences, and the proposed changes to LCR S05-09, are tabulated below.AooI 95-2168 REV. 7/99 JUL 2 0 2006 Document Control Desk LR-N06-0263 Differences between the Original LCR S05-09 Submittal and NUREG-1431 for Channel Functional Testing Monitor Original LCR S05-09 NUREG-1431 Requirement and Submittal Requirement Proposed Revision to LCR S05-09 Intermediate Start-up -if not ---NOTE---Range performed within the Only required when not performed within previous 184 previous 31 days days 1 Prior to reactor startup AND[Twelve] hours after reducing power below P-10 for power and intermediate range instrumentation AND Every 184 days thereafter This Surveillance shall include verification that interlocks P-6 and P-10 are in their required state for existing unit conditions.

Source Range Quarterly

--NOTE---AND Only required when not performed within previous 184 Start-up -if not days 1 performed within the previous 31 days Prior to reactor startup AND Four hours after reducing power below P-6 for source range instrumentation AND Every 184 days thereafter This Surveillance shall include verification that interlocks P-6 and P-10 are in their required state for existing unit conditions.

Power Range Quarterly

--NOTE--Only required when not performed within previous 184 days 1 Prior to reactor startup AND[Twelve] hours after reducing power below P-10 for power and intermediate range instrumentation AND Every 184 days thereafter This Surveillance shall include verification that interlocks P-6 and P-10 are in their required state for existing unit conditions.

I Note that Salem uses the calendar nomenclature of "6 Months" or "Semi-Annual (SA)" versus 184 days L 20 2006 Document Control Desk LR-N06-0263 PSEG has evaluated these differences and has concluded that alignment with NUREG-1431 is appropriate for these surveillance requirements at Salem. Therefore, we have made the additional required changes to the TS and are submitting them for your review and approval (Attachment 1).PSEG has determined that the No Significant Hazards Evaluation originally submitted for this License Change Request remains applicable for these additional changes; these additional changes only align the surveillance testing to the frequencies and requirements of NUREG-1431.

If you have any questions concerning this request, please contact Mr. Jamie Mallon at (610) 765-5507.I declare under penalty of perjury that the foregoing is true and correct.Executed on 17/1, ' (Date)Sincerely, Thomas P.loyce Site Vice President Salem Generating Station Attachments 1

Document Control Desk ML 0 205t LR-N06-0263 C Mr. S. Collins, Administrator

-Region I U. S. Nuclear Regulatory Commission 475 Allendale Road King of Prussia, PA 19406 U. S. Nuclear Regulatory Commission Mr. S. Bailey, Project Manager -Salem Unit 1 and Unit 2 Mail Stop 08B1 Washington, DC 20555-0001 USNRC Senior Resident Inspector

-Salem Unit 1 and Unit 2 (X24)Mr. K. Tosch, Manager IV Bureau of Nuclear Engineering PO Box 415 Trenton, New Jersey 08625 Attachment I LR-N06-0263 LCR S05-09 TECHNICAL SPECIFICATION PAGES WITH PROPOSED CHANGES The following additional Technical Specifications for Facility Operating License DPR-70 are affected by this supplemental change request: Technical Soecification Page Table 4.3-1 3/4 3-11, 3/4 3-13, and 3/4 3-13a The following additional Technical Specifications for Facility Operating License DPR-75 are affected by this supplemental change request: Technical Specification Page Table 4.3-1 3/4 3-11, 3/4 3-13, and 3/4 3-13a TABLE 4.3-1 REACTOR TRIP SYSTEM INSTRUMENTATION SURVEILLANCE REQUIREMENTS CHANNEL CHANNEL CHANNEL FUNCTIONAL CHECK CALIBRATION TEST N.A. N.A. R(9)S D(2), M(3) Note 15 and Q(")FUNCTIONAL UNIT 1. Manual Reactor Trip Switch 2. Power Range, Neutron Flux MODES IN WHICH SURVEILLANCE REQUIRED 1, 2, and *1, 2, and 3*I 3. Power Range, Neutron Flux, High Positive Rate 4. Power Range, Neutron Flux, High Negative Rate 5. Intermediate Range, Neutron Flux 6. Source Range, Neutron Flux -7. Overtemperature AT 8. Overpower AT 9. Pressurizer Pressure--Low

10. Pressurizer Pressure--High

11. Pressurizer Water Level--High

12. Loss of Flow -Single Loop N.A.N.A.S S S S S S S Q Q R(6)R(6)R(6)R R R R R R Note 15 Note 15 Q Q Q Q Q Q 1, 2 1, 2 i**, 2*** and *2****, 3, 4, 5 and *1, 2 1, 2 1, 2 1, 2 1, 2 1 SALEM -UNIT 1 II 3/4 3-11 Amendment No. 2,-a TABLE 4.3-1 (Continued)

NOTATION With the reactor trip system breakers closed and the control rod drive system capable of rod withdrawal.

• • Below the P-10 (Power Range Neutron Flux) interlocks.

Above the P-6 (Intermediate Range Neutron Flux) interlocks.

Below the P-6 (Intermediate Range Neutron Flux) interlocks.

(1) -If not performed in previous 31 days.(2) -Heat balance only, above 15% of RATED THERMAL POWER.(3) -Compare incore to excore axial offset above 15% of RATED THERMAL POWER.Recalibrate if absolute difference 3 percent.(4) -Manual SSPS functional input check every 18 months. **(5) -Each train or logic channel shall be tested at least every 62 days on a STAGGERED TEST BASIS.(6) -Neutron detectors may be excluded from CHANNEL CALIBRATION.

(7) -Below P-6 (Block of Source Range Reactor Trip) setpoint.(8) -Deleted (9) -The CHANNEL FUNCTIONAL TEST shall independently verify the OPERABILITY of the Undervoltage and Shunt Trip mechanism for the Manual Reactor Trip Function.The Test shall also verify OPERABILITY of the Bypass Breaker Trip circuits.(10) -DELETED (11) -The CHANNEL FUNCTIONAL TEST shall independently verify the OPERABILITY of the Reactor Trip Breaker Undervoltage and Shunt Trip mechanisms.

(12) -DELETED** A one time extension to this surveillance requirement which is satisfied by performance of the Manual SI test is granted during fuel cycle thirteen allowing Unit 1 operations to continue to the thirteenth refueling outage (IR13). The surveillance testing is to be completed at the appropriate time during the 1R13 outage, prior to the unit returning to Mode 4 upon outage completion.

SALEM -UNIT 1 3/4 3-13 Amendment No. 2 TABLE 4.3-1 (Continued)

NOTATION (13) -Verify operation of Bypass Breakers Shunt Trip function from local pushbutton while breaker is in the test position prior to placing breaker in service.(14) -Perform a functional test of the Bypass Breakers U.V. Attachment via the SSPS.(15) NOTE -Only required when not performed within previous 6 months I Prior to reactor startup AND Twelve hours after reducing power below P-10 for power and intermediate range instrumentation AND Four hours after reducing power below P-6 for source range instrumentation AND Every 6 months thereafter This Surveillance shall include verification that interlocks P-6 and P-10 are in their reauired state for existina unit conditions.

SALEM -UNIT 1 1 3/4 3-13a Amendment No. 9-S I REACTOR UNCTIONAL UNIT Manual Reactor Trip Switch Power Range, Neutron Flux Power Range, Neutron Flux, High Positive Rate* Power Range, Neutron Flux, High Negative Rate Intermediate Range, Neutron Flux Source Range, Neutron Flux Overtemperature AT* Overpower AT.Pressurizer Pressure--Low

.0. Pressurizer Pressure--High

.1. Pressurizer Water Level--High

.2. Loss of Flow -Single Loop TABLE 4.3-1 TRIP SYSTEM INSTRUMENTATION SURVEILLANCE REQUIREMENTS CHANNEL CHANNEL CHANNEL FUNCTIONAL CHECK CALIBRATION TEST N.A. N.A. R(9)S D(2), M(3) Note 15 N.A.N.A.S S(7)S S S S S S and Q(5)R(6)R(6)R (6)R (6)R R R R R R Q Q Note 15 Note 15 Q Q Q Q Q Q MODES IN WHICH SURVEILLANCE REQUIRED 1, 2, and 1, 2 and 3*1, 2 1, 2 I**, 2*** and *2****, 3, 4, 5 & *1, 2 1, 2 1, 2 1, 2 1, 2 1-ALEM -UNIT 2 3/4 3-11 Amendment No.-4O I TABLE 4.3-1 (Continued)

NOTATION* With the reactor trip system breakers closed and the control rod drive system capable of rod withdrawal.

• • Below the P-10 (Power Range Neutron Flux) interlocks.

Above the P-6 (Intermediate Range Neutron Flux) interlocks.

Below the P-6 (Intermediate Range Neutron Flux) interlocks.

(1) -If not performed in previous 31 days.(2) -Heat balance only, above 15% of RATED THERMAL POWER.(3) -Compare incore to excore axial offset above 15% of RATED THERMAL POWER.Recalibrate if absolute difference 3 percent.(4) -Manual SSPS functional input check every 18 months.(5) -Each train or logic channel shall be tested at least every 62 days on a STAGGERED TEST BASIS.(6) -Neutron detectors may be excluded from CHANNEL CALIBRATION.

(7) -Below P-6 (Block of Source Range Reactor Trip) setpoint.(8) -Deleted (9) -The CHANNEL FUNCTIONAL TEST shall independently verify the OPERABILITY of the Undervoltage and Shunt Trip mechanism for the Manual Reactor Trip Function.The Test shall also verify OPERABILITY of the Bypass Breaker Trip circuits.(10) -DELETED (11) -The CHANNEL FUNCTIONAL TEST shall independently verify the OPERABILITY of the Reactor Trip Breaker Undervoltage and Shunt Trip mechanisms.

(12) -DELETED SALEM -UNIT 2 3/4 3-13 Amendment No. 1-& I i , I .TABLE 4.3-1 (Continued)

NOTATION (13) -Verify operation of Bypass Breakers Shunt Trip function from local pushbutton while breaker is in the test position prior to placing breaker in service.(14) -Perform a functional test of the Bypass Breakers U.V. Attachment via the SSPS.(15) NOTE -Only required when not performed within previous 6 months Prior to reactor startup AND Twelve hours after reducing power below P-10 for power and intermediate range instrumentation AND Four hours after reducing power below P-6 for source range instrumentation AND Every 6 months thereafter This Surveillance shall include verification that interlocks P-6 and P-10 are in their reauired state for existina unit conditions.

SALEM -UNIT 2 3/4 3-13a Amendment No. 157 I