Search by property

This page provides a simple browsing interface for finding entities described by a property and a named value. Other available search interfaces include the page property search, and the ask query builder.

List of results

• ML17335A178  + (ML17335A178)
• IR 05000315/1998015  + (ML17335A180)
• IR 05000315/1998219  + (ML17335A181)
• 05000315/LER-1998-036, :on 980723,discovered That Flow Indicator Had Not Been Calibr at TS Required Frequency.Caused by Inadequate Work Practices.Action Request Has Been Written to Calibr Component on Refueling Outage Basis  + (ML17335A182)
• ML17335A185  + (ML17335A185)
• ML17335A189  + (ML17335A189)
• ML17335A190  + (ML17335A190)
• ML17335A191  + (ML17335A191)
• ML17335A192  + (ML17335A192)
• ML17335A193  + (ML17335A193)
• 05000315/LER-1998-011, :on 980305,steel Containment Liner Pitting Was Is Excess of Design.Caused by Lack of Procedural Controls. Seals Were Removed,Containment Liner Plate Was Prepared & Coated & New Seals Applied  + (ML17335A194)
• 05000315/LER-1998-016, :on 980323,re non-safety Related Cables Routed to Safety Related Equipment.Lers 98-016-00 & 98-016-01 Retracted  + (ML17335A195)
• 05000315/LER-1998-023, :on 980416,potential Failure Due to Cross Train Routing of non-safety Related Cables Was Noted.Ler 98-023-00 & 98-023-01,retracted  + (ML17335A196)
• 05000315/LER-1998-018, :on 980505,use of RCP Seals as Alternate Boron Injection Flow Path Resulted in Unanalyzed Condition.Caused by Maintaining Temp Above Recommended Max Temp.Westinghouse Has Provided Technical Input on Issue  + (ML17335A197)
• ML17335A198  + (ML17335A198)
• ML17335A201  + (ML17335A201)
• IR 05000280/2018007  + (ML17335A202)
• ML17335A207  + (ML17335A207)
• ML17335A209  + (ML17335A209)
• ML17335A210  + (ML17335A210)
• ML17335A211  + (ML17335A211)
• ML17335A212  + (ML17335A212)
• ML17335A213  + (ML17335A213)
• ML17335A215  + (ML17335A215)
• ML17335A217  + (ML17335A217)

• ML17335A219  + (ML17335A219)

• ML17335A220  + (ML17335A220)
• ML17335A221  + (ML17335A221)
• 05000315/LER-1998-022, :on 980415,postulated Failure of SAT N Regulator Was Noted.Caused by Failure to Perform Adequate SE for Procedure rev.10CFR50.59 Program Has Been Upgraded to Meet Current Industry Standards.With  + (ML17335A222)
• ML17335A223  + (ML17335A223)
• ML17335A224  + (ML17335A224)
• ML17335A225  + (ML17335A225)
• 05000315/LER-1998-038, :on 980814,potential for Single Failure to Isolate ECCS Suction Paths Was Noted.Caused by Lack of Written Communication.Revised EOP to Correct Condition. with  + (ML17335A226)
• ML17335A227  + (ML17335A227)
• ML17335A229  + (ML17335A229)
• ML17335A230  + (ML17335A230)
• ML17335A231  + (ML17335A231)
• ML17335A233  + (ML17335A233)
• ML17335A234  + (ML17335A234)
• ML17335A237  + (ML17335A237)
• ML17335A239  + (ML17335A239)
• ML17335A241  + (ML17335A241)
• ML17335A242  + (ML17335A242)
• ML17335A244  + (ML17335A244)
• ML17335A245  + (ML17335A245)
• ML17335A248  + (ML17335A248)
• IR 05000315/1998016  + (ML17335A250)
• 05000315/LER-1998-040, :on 980831,ESF Actuation & Start of EDGs 1 Cd & 2 Cd,Occurred.Caused by Equipment Failure.Cable Fault Was Located & Failed Section Cut Out & Cable Spliced.With  + (ML17335A251)
• ML17335A252  + (ML17335A252)
• ML17335A253  + (ML17335A253)
• IR 05000315/1998019  + (ML17335A255)