Information Notice 2015-02, Antifreeze Agents in Fire Water Sprinkler Systems
ML14323A176 | |
Person / Time | |
---|---|
Issue date: | 02/04/2015 |
From: | Marissa Bailey, Michael Cheok, Kokajko L NRC/NMSS/FCSS, Division of Policy and Rulemaking, Office of Nuclear Regulatory Research |
To: | |
Mollie Semmes | |
References | |
IN-15-002 | |
Download: ML14323A176 (7) | |
UNITED STATES
NUCLEAR REGULATORY COMMISSION
OFFICE OF NUCLEAR REACTOR REGULATION
OFFICE OF NUCLEAR MATERIAL SAFETY AND SAFEGUARDS
OFFICE OF NEW REACTORS
WASHINGTON, DC 20555-0001 February 4, 2015 NRC INFORMATION NOTICE 2015-02: ANTIFREEZE AGENTS IN FIRE WATER
SPRINKLER SYSTEMS
ADDRESSEES
All holders of, and applicants for a specific source material license under Title 10 of the Code of
Federal Regulations (10 CFR) Part 40, Domestic Licensing of Source Material.
All holders of an operating license or construction permit for a nuclear power reactor issued
under 10 CFR Part 50, Domestic Licensing of Production and Utilization Facilities, including
those that have permanently ceased operations and certified that fuel has been permanently
removed from the reactor vessel.
All holders of, and applicants for an operating license for non-power reactors (research reactor, test reactor, or critical assembly) under 10 CFR Part 50, except those that have permanently
ceased operations and have returned all of their fuel to the U.S. Department of Energy.
All holders of, and applicants for a power reactor combined license, standard design approval, or manufacturing license under 10 CFR Part 52, Licenses, Certifications, and Approvals for
Nuclear Power Plants. All applicants for a standard design certification, including such
applicants after initial issuance of a design certification rule.
All holders of, and applicants for a fuel cycle facility license under 10 CFR Part 70, Domestic
Licensing of Special Nuclear Material.
All applicants for a construction permit for utilization or production facilities intended for medical
radioisotope production under 10 CFR Part 50 and 10 CFR Part 70.
PURPOSE
The U.S. Nuclear Regulatory Commission (NRC) is issuing this information notice (IN) to inform
addressees of recent Tentative Interim Amendments (TIAs) issued by the National Fire
Protection Association (NFPA) Standard Council to NFPA Standard 13, Standard for the
Installation of Sprinkler Systems (NFPA 13), and NFPA Standard 25, Standard for the
Inspection, Testing, and Maintenance of Water-Based Fire Protection Systems (NFPA 25).
The NRC expects recipients of this IN to review the information for applicability to their facilities
and consider actions, as appropriate to avoid similar problems. However, suggestions
ML14323A176 contained in this IN do not constitute NRC requirements; therefore, no specific action or written
response is required.
DESCRIPTION OF CIRCUMSTANCES
The intent of antifreeze sprinkler systems is to protect sprinkler piping that passes through areas
that could be exposed to freezing temperatures. For example, antifreeze sprinkler systems may
be used in freezers, loading docks, unheated warehouses, elevator shafts, or unconditioned
areas. Sprinkler systems utilizing antifreeze agents may be present at some NRC licensed
facilities; however, antifreeze sprinkler systems would not typically be installed in safety-related
areas. The NRC is using this IN to heighten awareness and inform licensees of the issue.
NFPA 13 only permits the use of non-toxic antifreeze solutions. NFPA 13 references NFPA 25 for regular inspection, testing and maintenance requirements of antifreeze sprinkler systems to
verify that an antifreeze sprinkler system has the proper concentration of antifreeze solution.
NFPA began researching the possible effects of antifreeze use in sprinkler systems in 2009.
NFPA found that concentrations of 70 percent glycerine or 60 percent propylene glycol in water
may be ignited when discharged through sprinkler systems resulting in a substantial fire event.
Glycerine and propylene glycol, in pure form, are Class IIIB combustible liquids having
flashpoints of 390° Fahrenheit (F) (199° Celsius (C)) and 210° F (99°C) respectively.
Depending upon concentration, the addition of water limits the flammability of each compound.
NFPA 13 recognizes that in some instances antifreeze solutions may contribute to a fire
condition, but that the supply of water following the antifreeze solution mitigates the contribution
to the fire.
Following NFPAs completion of full-scale fire tests, the NFPA issued TIAs in March 2011 on
NFPA 13 and NFPA 25. The most current provisions regarding antifreeze are contained in
the 2013 Edition of NFPA 13 and the 2014 Edition of NFPA 25. The changes to the NFPA
codes that may be applicable to licensed facilities for existing construction are as follows 1:
New Sprinkler Systems (i.e., installed after September 30, 2012) Containing
Antifreeze - NFPA 13 . . . Sprinkler Systems
With limited exceptions, all new antifreeze systems (systems installed after
September 30, 2012) are required to use listed antifreeze solutions. The listing
of the antifreeze solution must indicate that the solution will not ignite when
discharged from a sprinkler. The exceptions to the requirement for listed
antifreeze solutions are as follows:
- Factory premixed antifreeze solutions of propylene glycol in excess of 40%
by volume are permitted in ESFR (Early Suppression Fast Response)
sprinkler systems where the sprinklers are listed for such use in a specific
application. The listing will indicate the maximum percentage of propylene
glycol that can be used with the specific sprinkler. . . .
1 The following text on existing and new sprinkler systems is an excerpt from www.nfpa.org/antifreeze, January 2014 * . . . New systems, once installed, must be annually tested in the manner
required for existing systems, summarized below.
Existing NFPA 13 . . . Sprinkler Systems
The testing and maintenance provisions for NFPA 13antifreeze systems are
governed by NFPA 25. NFPA 25 provides that, by September 2022, existing
systems (systems installed [before] September 30, 2012), like new systems, will
be required to use only listed antifreeze solutions. Until then, traditional
antifreeze solutions may continue to be used where certain conditions, confirmed
by annual testing, have been met, summarized as follows.
Until a listed non-combustible solution is introduced into the system, antifreeze
solutions in existing systems must be tested annually, prior to the onset of
freezing weather.
- If it is determined, based on records, tests or other reliable information that
the solution found in the system is no longer permitted or if the type of anti- freeze cannot be reliably determined, the system must be drained and
replaced with an acceptable factory premixed solution.
- If the initial review indicates that the solution type is acceptable, test samples
must be taken at the top and bottom of each system (in some cases an
additional sample must be taken).
- If all the test samples indicate a concentration of glycerine not greater than
38% by volume or propylene glycol not greater than 30% by volume, then the
solution is permitted and may remain in the system.
- Where the test samples indicate that the solution is between 38% and 50%
glycerine or 30% and 40% propylene glycol, the solution may remain in the
system pending the approval of a deterministic risk assessment (see NFPA
25: 5.3.4.2.1(3)).
- If any of the samples indicate a concentration in excess of 50% glycerine or
40% propylene glycol, the system must be emptied and refilled with an
acceptable solution or an alternate method of freeze protection must be
employed. An acceptable solution would be a solution that contains less than
38% glycerine or 30% propylene glycol, or a solution that has been approved
by the AHJ based on a deterministic risk assessment.
- All traditional antifreeze solutions must be replaced by listed antifreeze
solutions, or alternative freeze protection methods, by September 2022.
BACKGROUND
As stated in 10 CFR 50.48, Fire protection, each operating nuclear power plant must have a
fire protection plan that satisfies Criterion 3, Fire protection, in Appendix A, General Design
Criteria for Nuclear Power Plants, to 10 CFR Part 50. The purpose of these requirements is to
minimize the probability and effects of fires. 10 CFR 40.32, General requirements for issuance of specific licenses, and 10 CFR Part 70
Subpart H, Additional Requirements for Certain Licensees Authorized To Possess a Critical
Mass of Special Nuclear Material, establish the NRC's fire protection program requirements for
fuel cycle facilities. The purpose of these requirements is to safeguard any nuclear material on
site and protect the public from radioactive releases due to a fire event.
NUREG-1537: Part 1, "Guidelines for Preparing and Reviewing Applications for the Licensing of
Non-Power Reactors: Format and Content, February 1996 (Agencywide Documents Access
and Management System (ADAMS) Accession No. ML042430055) describes the fire protection
guidance for non-power reactors. Fire protection guidance for medical radioisotope production
facilities is described in the Final Interim Staff Guidance Augmenting NUREG-1537, Part 1, Guidelines for Preparing and Reviewing Applications for the Licensing of Non-Power Reactors:
Format and Content, for Licensing Radioisotope Production Facilities and Aqueous
Homogeneous Reactors, October 2012 (ADAMS Accession No. ML12156A069). These
facilities are expected, at a minimum, to be in compliance with all local building and fire codes.
Although there is no NRC requirement to do so, these facilities may also make a commitment to
follow nationally recognized codes and standards in order to demonstrate reasonable assurance
of fire safety.
DISCUSSION
Existing research and testing performed by NFPA suggests that under certain conditions, antifreeze-water mixtures discharged from fire sprinklers can accelerate a fire when sprayed
onto a flame. Increasing the concentration of the antifreeze in the antifreeze-water solution
increases the combustibility of the solution. Additionally, existing research indicates that under
certain conditions, the energy release rate of some fires increases upon interaction with
antifreeze-water mixtures.
For nuclear power plants, non-power reactors, medical radioisotope production facilities, and
fuel cycle facilities in areas where temperatures routinely go below freezing, some licensees
may have determined that antifreeze is a necessary feature to ensure that sprinklers will
operate in the event of a fire. NFPA standards indicate that annual testing is part of
maintenance of sprinkler systems with antifreeze to determine the concentration of antifreeze
agent present. NFPA recommends that samples be taken at the highest and lowest practical
elevations of the system since antifreeze solutions can be unevenly distributed, resulting in
pockets with high antifreeze concentrations. If the limits are above those from the NFPA TIA,
licensees may drain their sprinkler system and replace it with a premixed water-antifreeze
solution as prescribed in the second TIA. Doing so would reduce the risk of fire-spread or
explosion due to excessive concentration of antifreeze in the sprinkler discharge.
For locations where the new antifreeze concentration limits are not sufficient to prevent freezing
of sprinkler systems, the NFPA suggests pipe insulation, heating systems, or the use of dry pipe
or pre-action systems as alternatives. For existing antifreeze systems that have antifreeze
concentrations that exceed the information in the recent NFPA TIA, NFPA states that the
sprinkler system, must be emptied and refilled with an acceptable solution or an alternative
method of freeze protection must be employed. Information Notice 2013-06: Corrosion in Fire
Protection Piping Due to Air and Water Interaction, provides information regarding concerns when fire protection piping is drained and refilled and air remains in the piping. In addition, although this IN is not a regulatory requirement, it informs licensees of the potential of antifreeze
from such systems to be combustible, and therefore, consideration of antifreeze as a
combustible would be treated in accordance with a facilitys fire protection program.
At the time this IN was issued, several listed factory premixed antifreeze solutions were on the
market. For new sprinkler systems that require the use of antifreeze, NFPA recommends
alternative measures, such as those described in the previous paragraph. NFPA 13, 9.2.2.3 states that the concentration of antifreeze solutions shall be limited to the minimum necessary
for the anticipated minimum temperature
This is an ongoing issue, with updates available through NFPA (http://www.nfpa.org/antifreeze).
It is recommended that licensees keep up-to-date with the newest developments. For additional
information, licensees can read the applicable TIAs for the complete set of proposed code
changes and visit the NFPA website for updates (http://www.nfpa.org/codes-and- standards/standards-development-process/tias-errata-and-fis).
CONTACT
S
This IN requires no specific action or written response. If you have any questions about the
information in this notice, please contact the technical contact listed below or the appropriate
NRC regional office.
/RA/ /RA/
Michael C. Cheok, Director Lawrence E. Kokajko, Director
Division of Construction Inspection Division of Policy and Rulemaking
and Operational Program Office of Nuclear Reactor Regulation
Office of New Reactors
/RA/
Marissa G. Bailey, Director
Division of Fuel Cycle Safety, Safeguards, and Environmental Review
Office of Nuclear Material Safety
and Safeguards
Technical Contact:
Mollie Semmes, NMSS/FCSE
(301) 287-9107 mollie.semmes@nrc.gov
ML14323A176 *concurred via-email
OFFICE NMSS/ QTE NMSS/ NMSS/ NMSS/ NMSS/ NRR/DRA/ NRR/DPR
FCSE/ECB FCSE/ECB FCSE/ECB MSEB FCSE AFPB / PROB
NAME MSemmes CHsu* BSmith DMiller AMcIntosh* CErlanger AKlein* KHsueh*
DATE 11/19/14 12/9/14 12/3/14 11/19/14 10/28/14 12/4/14 1/7/15 1/5/15 OFFICE NRR/DPR/ NRR/DPR/ NRR/DPR NRR/DPR RES/DRA NRO/DCIP NMSS:FCS
PGCB PGCB E
NAME ELee SStuchell* AMohseni LKokajko RCorreia* MCheok MBailey
DATE 1/5/15 1/5/15 1/9/15 1/ 23 /15 1/30/15 2/2/15 2/4/15
1/22/15