ML073400147

NFPA 805 Transition Pilot Plant FAQ 06-0025, Revision 3

ML073400147
Person / Time
Site:	Harris
Issue date:	12/06/2007
From:	Holder A Progress Energy Carolinas
To:	Office of Nuclear Reactor Regulation
References
FAQ 06-0025, NEI 04-02, NFPA 805
Download: ML073400147 (6)

Text

FAQ Number 06-0025 FAQ Revision 3a FAQ Title Scope and Content of Pre-Fire Plans Page 1 of 6 Plant: Harris Nuclear Plan (HNP) Date:12-07-07 Contact: Alan Holder Phone:919-546-3372 Email:alan.holder@pgnmail.com Distribution: (NEI Internal Use) 805 TF FPWG FPRATF Purpose of FAQ:

FAQ seeks clarification to define the minimum acceptable scope and content for Pre-Fire Plans.

Is this Interpretation of guidance?

Yes / No Proposed new guidance not in NEI 04-02?

Yes / No Details: NEI 04-02 guidance needing interpretation (include section, paragraph, and line numbers as applicable):

NEI 04-02, Section 4.3.1, Fundamental Fire Protection Program and Design Elements Transition Review, should refer to a new appendix which lists interpretation of specific sections of NFPA 805 Chapter 3 Circumstances requiring guidance interpretation or new guidance:

Clarification of NFPA-805, Standard for Fire Protection for Light Water Reactor Electric Generating Plants (2001 Edition), Chapter 3, Section 3.4, Industrial Fire Brigade, section 3.4.2.1, "The plans shall detail the fire area configuration and fire hazards to be encountered in the fire area, along with any nuclear safety components and fire protection systems and features that are present."

Specifically, define the minimum acceptable scope and content for Pre-Fire Plans.

Detail contentious points if licensee and NRC have not reached consensus on the facts and circumstances:

NA

FAQ Number 06-0025 FAQ Revision 3a FAQ Title Scope and Content of Pre-Fire Plans Page 2 of 6 Potentially relevant existing FAQ numbers:

FAQ #06-0007 Response Section:

Proposed resolution of FAQ and the basis for the proposal:

This FAQ seeks to define minimum acceptable pre-fire plan scope and content. Current guidance is found in regulatory documents such as 10CFR50, Appendix R, Section K, NUREG 0800 and the FRAQA letter (see comparison table below). This FAQ provides clarification for continued use of this scope and content through inclusion in NEI 04-02, Appendix K.

During development of the FAQ, Regulatory Guide 1.189 Revision 1 was issued, while not a part of a transitioning plant's CLB, this guidance included two additional topical areas for pre-fire plans. R.G. 1.189, Section 3.5.1.3(c)ii. "SSCs credited for fire safe shutdown", and xii. "communications between the fire brigade leader, fire brigade, offsite mutual aid responders, control room, and licensee's emergency response organization". Identification of SSCs credited for safe shutdown for firefighting purposes is satisfied by NFPA 805, Section 3.4.2.1, while communications is described in NFPA 805 section 3.4.2.4 and the sixth and tenth bullets of the specific clarification proposed below.

FAQ Number06-0025 FAQ Revision 3a FAQ TitleScope and Content of Pre-Fire Plans Page 3 of 6 NUREG 0800 Define the strategies for fighting fires in all safety-related areas and areas presenting a hazard to safety-related equipment. These strategies should designate:

10CFR50, Appendix R (III.K.12) Define the strategies for fighting fires in all safety-related areas and areas presenting a hazard to safety-related equipment. These strategies should designate:

FRACQA Letter (06/20/77) The strategies established for fighting fires in all safety-related areas and areas presenting a hazard to safety-related equipment. As a minimum the following subjects should be covered: NFPA 805 (FAQ 06-0025) As a minimum, the pre-fire plans should include a description of the following:

Fire hazards in each area covered by the specific pre-fire plans. Fire hazards in each area covered by the specific pre-fire plans. Identification of combustibles in each plant zone covered by the specific fire fighting procedures.

Fire extinguishants best suited for controlling the fires associated with the fire hazards in that area and the nearest location of these extinguishants. Fire extinguishants best suited for controlling the fires associated with the fire hazards in that area and the nearest location of these extinguishants. Fire extinguishants best suited for controlling the fires associated with the combustible loadings in that zone and the nearest location of these extinguishants. Available fire protection systems Fire extinguisher locations Most favorable direction from which to attack a fire in each area in view of the ventilation direction, access hallways, stairs, and doors that are most likely to be free of fire, and the best station or elevation for fighting the fire.

All access and egress routes that involve locked doors should be specifically identified in the procedure with the appropriate precautions and methods for access specified. Most favorable direction from which to attack a fire in each area in view of the ventilation direction, access hallways, stairs, and doors that are most likely to be free of fire, and the best station or elevation for fighting the fire.

All access and egress routes that involve locked doors should be specifically identified in the procedure with the appropriate precautions and methods for access specified. Most favorable direction from which to attack a fire in each area, in view of the ventilation direction, access hallways, stairs and doors which are most likely to be fire-free, and the best station or elevation for fighting the fire.

A specific identification system shall designate all hallways, stairs, doors fire equipment and system control locations, and other items described in the fire fighting procedures. This identification should be used in the procedures and the corresponding plant items should be prominently marked so that they can be recognized in dim light. All access and egress routes that involve locked doors should Fire barriers Fire doors Locked doors Inaccessible of limited access areas FAQ Number06-0025 FAQ Revision 3a FAQ TitleScope and Content of Pre-Fire Plans Page 4 of 6 be specifically identified in the procedure with the appropriate precautions and methods for access specified. Plant systems that should be managed to reduce the damage potential during a local fire and the location of local and remote controls for such management (e.g., any hydraulic or electrical systems in the zone covered by the specific fire fighting procedure that could increase the hazards in the area because of overpressurization or electrical hazards). Plant systems that should be managed to reduce the damage potential during a local fire and the location of local and remote controls for such management (e.g., any hydraulic or electrical systems in the zone covered by the specific fire fighting procedure that could increase the hazards in the area because of overpressurization or electrical hazards). Designation of plant systems that should be managed to reduce the damage potential during a local fire; location of local and remote controls for such management (e.g., any hydraulic or electrical systems in the zone covered by the specific fire fighting procedure that cold increase the hazards in the area because of overpressurization or electrical hazards). Safe shutdown equipment Vital heat-sensitive system components that need to be kept cool while fighting a local fire. Particularly hazardous combustibles that need cooling should be designated. Vital heat-sensitive system components that need to be kept cool while fighting a local fire. Particularly hazardous combustibles that need cooling should be designated. Designation of vital heat-sensitive system components that need to be kept cool while fighting a local fire. Critical equipment which are particularly hazardous combustible sources should be designated to receive cooling.

Organization of fire fighting brigades and the assignment of special duties according to job title so that all fire fighting functions are covered by any complete shift personnel complement. These duties include command control of the brigade, transporting fire suppression and support equipment top the fire scenes, applying the extinguishant to the fire, communication with the Organization of fire fighting brigades and the assignment of special duties according to job title so that all fire fighting functions are covered by any complete shift personnel complement. These duties include command control of the brigade, transporting fire suppression and support equipment top the fire scenes, applying the extinguishant to the fire, communication with the Organization of fire fighting brigades and the assignment of special duties according to job title so that all fire fighting functions are covered by any complete shift personnel complement. These duties include command control of the brigade, fire hose laying, applying the extinguishant to the fire, advancing support supplies to the fire scene, communication with the control room, Communication equipment FAQ Number06-0025 FAQ Revision 3a FAQ TitleScope and Content of Pre-Fire Plans Page 5 of 6 control room, and coordination with outside fire departments. control room, and coordination with outside fire departments. coordination with outside fire departments. Potential radiological and toxic hazards in fire zones Potential radiological and toxic hazards in fire zones. Identification radiological and toxic hazards in fire zones. Radiological hazards Special hazards Pre-fire plans should detail radiologically hazardous areas and radiation protection barriers. Ventilation system operation that ensures desired plant air distribution when the ventilation flow is modified for fire containment or smoke clearing operation. Ventilation system operation that ensures desired plant air distribution when the ventilation flow is modified for fire containment or smoke clearing operation. Ventilation system operation that ensures desired plant air pressure distribution when the ventilation flow is modified for fire containment or smoke clearing operations. Ventilation capabilities Methods of smoke and heat removal should be identified for all fire areas in the pre-fire plans. These can include the use of dedicated smoke and heat removal systems or use of the structure's heating ventilating and air-conditioning (HAC) system if it can operate in the 100 percent exhaust mode. Operations requiring control room and shift engineer coordination or authorization. Operations requiring control room and shift engineer coordination or authorization. Operations requiring control room and shift engineer coordination or authorization. Areas subject to flooding Water drainage methods should be reviewed and included in the pre-fire plan for each area. Instructions for plant operators and general plant personnel during fire. Instructions for plant operators and general plant personnel during fire. Instructions for plant operators and general plant personnel during fire.

FAQ Number 06-0025 FAQ Revision 3a FAQ Title Scope and Content of Pre-Fire Plans Page 6 of 6 If appropriate, provide proposed rewording of guidance for inclusion in the next Revision:

Clarification of specific sections of NFPA 805 as applied under 10 CFR 50.48(c), will be included in a new Appendix K, to NEI 04-02 (final formatting to be provided by NEI).

Include the following information in Appendix K:

NFPA 805, Section 3.4 Clarification:

As a minimum, the pre-fire plans should define the strategies for fighting fires in all areas in which a fire could jeopardize the ability to meet the performance criteria described in Section 1.5. These pre-fire plans should designate:

Fire hazards in each area covered by the specific pre-fire plans. Fire extinguishants best suited for controlling the fires associated with the fire hazards in that area and the nearest location of these extinguishants. Most favorable direction from which to attack a fire in each area in view of the ventilation direction, access hallways, stairs, and doors that are most likely to be free of fire, and the best station or elevation for fighting the fire. All access and egress routes that involve locked doors should be specifically identified in the procedure with the appropriate precautions and methods for access specified. Plant systems that should be managed to reduce the damage potential during a local fire and the location of local and remote controls for such management (e.g., any hydraulic or electrical systems in the zone covered by the specific fire fighting procedure that could increase the hazards in the area because of overpressurization or electrical hazards). Vital heat-sensitive system components that need to be kept cool while fighting a local fire. Particularly hazardous combustibles that need cooling should be designated. Organization of fire fighting brigades and the assignment of special duties according to job title so that all fire fighting functions are covered by any complete shift personnel complement. These duties include command control of the brigade; transporting fire suppression and support equipment top the fire scenes, applying the extinguishant to the fire, communication with the control room, and coordination with outside fire departments. Potential radiological and toxic hazards in fire zones Ventilation system operation that ensures desired plant air distribution when the ventilation flow is modified for fire containment or smoke clearing operation. Operations requiring control room and shift engineer coordination or authorization. Instructions for plant operators and general plant personnel during fire.