ML17094A672

McGuire, Units 1 and 2, Issue Selected License Commitment Cslcl 16.7.14 Revision

ML17094A672
Person / Time
Site:	McGuire, Mcguire
Issue date:	03/29/2017
From:	Duke Energy Corp
To:	Document Control Desk, Office of Nuclear Reactor Regulation
References
Download: ML17094A672 (4)

Text

Distribution:

1. Boyer, Robert P 2. Gardner, Troy R 3. Howell, Pamela T 4. Mc Ginnis, Vickie L s. OPS TRNG MGR. 6. RESIDENT NRC INSPECT 7. SERV BLDG FILE ROOM -8. U S NUC REG WASHINGTON, DC 9. USN RC Remarks:

Duke Energy DOCUMENTTRANSMITTALFORM Date: 3/29/2017 Document Transmittal

1. TR-NUC-MC-005650 Purpose:

Inn 1-------------------------1 Released By: Facility:

MCGUIRE NUCLEAR STATION SUBJECT Issue Selected License Commitment CSLCl 16.7.14 Revision Page 1of1 2 3 4 5 FYIIE FYIIE FYIIE R&AIE Duke Energy 13225 Hagers Ferry Road Document Management MG02DM Huntersville.

NC 28078 MNSDCRM@duke-energy.com 6 7 8 PRINTILP FYIIE R&AIE 9 R&AIE 16.7 INSTRUMENTATION Source Range HF@SD Alarm 16.7.14 16.7.14 Source Range High Flux at Shutdown (HF@SD) Alarm COMMITMENT APPLICABILITY At least one channel of source range shall be FUNCTIONAL with: a. HF@SD alarm sets 2.12 times background,

b. Visual and audible alarm. MODE 3 below P-6 permissive with one HF@SD alarm in normal, MODES 4 and 5. REMEDIAL ACTIONS CONDITION REQUIRED ACTION COMPLETION TIME A. No functional source range HF@SD alarm ---------------NOTE--------------------

Plant temperature changes are allowed provided that SOM is maintained and Keff remains < 0.99. A.1 Suspend operations Immediately involving positive reactivity additions.

A.2 Close unborated water source isolation valves. 1 hour1.157407e-5 days <br />2.777778e-4 hours <br />1.653439e-6 weeks <br />3.805e-7 months <br /> A.3 Verify SOM is within the 1 hour1.157407e-5 days <br />2.777778e-4 hours <br />1.653439e-6 weeks <br />3.805e-7 months <br /> limit specified in the COLR Once per 12 hours1.388889e-4 days <br />0.00333 hours <br />1.984127e-5 weeks <br />4.566e-6 months <br /> thereafter A.4 Initiate action to restore Immediately one source range HF@SD alarm. McGuire Units 1and2 16.7.14-1 Revision 160 Source Range HF@SD Alarm 16.7.14 TESTING REQUIREMENTS TEST TR 16.7.14.1 Perform CHANNEL CHECK TR 16. 7 .14.2 ------------------------------NOTE------------------------------------

BASES Neutron detectors are excluded from CHANNEL CALIBRATION.

Perform CHANNEL CALIBRATION.

FREQUENCY 12 hours1.388889e-4 days <br />0.00333 hours <br />1.984127e-5 weeks <br />4.566e-6 months <br /> 18 months The source range neutron flux monitors are used during shutdown modes of operation to monitor the core reactivity condition.

The installed source range neutron flux monitors are available from the Nuclear Instrumentation System (NIS) or from the Wide Range Neutron Flux Monitoring System (Gamma-Metrics).

Source range indication is provided via the NIS source range channels and the Gamma-Metrics shutdown monitors using detectors located external to the reactor vessel. These detectors monitor neutrons leaking from the core. Neutron flux indication for these monitors are provided in counts per second (CPS). The NIS source range channels and the Gamma-Metrics shutdown monitors provide continuous visible count rate indication in the Control Room and a high flux control room alarm to alert operators to any unexpected positive reactivity additions.

The FUNCTIONALITY of the source range (SR) high flux at shutdown (HF@SD) alarm is for detection of an inadvertent boron dilution event. The source range monitor may consist of any channel of an NIS monitor or a wide range neutron flux (WRNF) monitor.

The NIS SR HF@SD alarm provides a visual alarm indication on the respective NIS SR drawer, visual and audible alarm notification from AD2-D3, "S/R HI FLUX AT SHUTDOWN",

visual and audible alarm notification from the Operator Aid Computer (OAC) and audible alarm from the containment evacuation alarm inside containment.

The WRNF SR HF@SD alarm provides visual alarm indication on main control board MC2 and visual and audible alarm from AD2-D3, "S/R HI FLUX AT SHUTDOWN".

NIS audible alarm requires the respective source range drawer high flux at shutdown switch in NORMAL. WRNF audible alarm requires the respective SHUTDOWN MONITOR ANNUNCIATOR BYPASS switch in NORMAL FUNCTIONALITY requires at least one channel with its detector monitoring neutron leakage from the core with visual and audible alarm notification from the HF@SD alarm configured at s 2.12 times background.

Audible alarm notification may consist of either the plant annunciator system or OAC. Alarm setpoint shall bes 2.12 (alarm ratio of 2.0) times background.

Background is the average CPS neutron level reading (the average CPS reading is the most consistent value between highest and lowest CPS neutron level reading).

The source range shutdown margin monitor (SDMM) measures the source range count-rate and identifies any statistically significant increase in counts that could suggest a _ loss of reactor shutdown margin. McGuire Units 1 and 2 16.7.14-2 Revision 160 Source Range HF@SD Alarm 16.7.14 Selection of HF@SD alarm setpoint of 2.12 is based upon industry operating experience that determined source range (SR)

Nuclear Instrumentation response lagged the reactivity change experienced by the core which occurred at substantially subcritical, rodded conditions.

This is due to low-leakage core loading patterns with high-burnup fuel on the core periphery (and without secondary sources) that affect SR response in a manner that departs from traditional subcritical multiplication theory. The maximum setpoint calculated by the SDMM is 2.12 with an alarm ratio multiplier selection of 2.0. Analysis has shown that a HF@SD alarm setpoint of 2.12 is sufficient to compensate for the lagged detector response under these conditions and provide ample time for Operators to terminate a dilution event once the HF@SD alarm activates.

The SLC APPLICABILITY is Modes 3 (below P-6 permissive with one HF@SD alarm in normal),

4 and 5. On shutdown, the source range monitors provide a valid alarm once below the P-6 permissive and the monitors on scale. On start-up, the HF@SD alarms are blocked in Mode 3 just prior to control rod withdrawal.

During these brief periods when the HF@SD alarms are blocked in Mode 3, SOM is maintained in accordance with TS 3.1.1. Condition A applies when the required number of FUNCTIONAL source range HF@SD alarms are not met in Modes 3 (below P-6 permissive with one HF@SD alarm in normal),

4, or 5. With the unit in this condition, the source range HF@SD alarm performs a monitoring function.

With less than the required number of source range HF@SD alarms FUNCTIONAL, operations involving positive reactivity additions shall be suspended immediately.

In addition to suspension of positive reactivity additions, all valves that could add unborated water to the reactor coolant system (RCS) must be closed within 1 hour1.157407e-5 days <br />2.777778e-4 hours <br />1.653439e-6 weeks <br />3.805e-7 months <br />. The isolation of unborated water sources will preclude a boron dilution accident.

Also, the shutdown margin (SOM) must be verified within 1 hour1.157407e-5 days <br />2.777778e-4 hours <br />1.653439e-6 weeks <br />3.805e-7 months <br /> and once every 12 hours1.388889e-4 days <br />0.00333 hours <br />1.984127e-5 weeks <br />4.566e-6 months <br /> thereafter as per TS SR 3.1.1.1, SOM verification.

With no source range HF@SD alarm FUNCTIONAL, core monitoring is severely reduced.

Verifying the SOM within 1 hour1.157407e-5 days <br />2.777778e-4 hours <br />1.653439e-6 weeks <br />3.805e-7 months <br /> allows sufficient time to perform the calculations and determine that the SOM requirements are met. The SOM must also be verified once per 12 hours1.388889e-4 days <br />0.00333 hours <br />1.984127e-5 weeks <br />4.566e-6 months <br /> thereafter to ensure that the core reactivity has not changed.

Required Action A.1 precludes any positive reactivity additions; therefore, core reactivity should not be increasing, and a 12 hour1.388889e-4 days <br />0.00333 hours <br />1.984127e-5 weeks <br />4.566e-6 months <br /> Frequency is adequate.

The Completion Times of within 1 hour1.157407e-5 days <br />2.777778e-4 hours <br />1.653439e-6 weeks <br />3.805e-7 months <br /> and once per 12 hours1.388889e-4 days <br />0.00333 hours <br />1.984127e-5 weeks <br />4.566e-6 months <br /> are based on operating experience in performing the Required Actions and the knowledge that unit conditions will change slowly. Required Action A.1 is modified by a note which permits plant temperature changes provided the temperature change is accounted for in the calculated SOM and that Keff remains < 0.99. Introduction of temperature

changes, including temperature increases when a positive moderator temperature coefficient (MTC) exists, must be evaluated to ensure they do not result in a loss of required SOM or adequate margin to criticality.

REFERENCES

1. SER Supplement 1 Section 15.2.1 2. UFSAR Sections 7.7.1.3.1and15.4.6

3. Commitment Change 201 O-M-002 4. Commitment Change 2014-M-001

5. Commitment Change 2015-M-002

6. NRC Generic Letter 85-05, "Inadvertent Boron Dilution Events" dated January 31, 1985 . 7. MCC-1552.08-00-0136 Rev. 08, "Generic FSAR Boron Dilution Accident Analysis" McGuire Units 1 and 2 16.7.14-3 Revision 160