| | Q | CCA | Title |
|---|
| 05000454/FIN-2010007-03 | 2010Q3 | | Licensee ISFSI Annulus Cooling System Important to Safety Classification |
| 05000454/FIN-2010007-01 | 2010Q3 | | Inadequate Procedures for Implementing FSAR Required Annulus Cooling |
| 05000454/FIN-2010004-02 | 2010Q3 | | Relying on the Use of Friction as a Restraining Force when the HI-TRAC is Placed on top of the HI-STORM |
| 05000454/FIN-2010004-01 | 2010Q3 | H.7 | Failure to Perform Adequate Evaluation for Crane Upgrade |
| 05000454/FIN-2010007-02 | 2010Q3 | | Non-Inert Atmosphere May Challenge Fuel Integrity |
| 05000454/FIN-2010007-04 | 2010Q3 | | Thermal Models in FSAR Design Basis Analysis May Not be Conservative |
| 05000454/FIN-2010005-02 | 2010Q4 | | Inadequate Procedures for Implementing FSAR Required Annulus Cooling |
| 05000454/FIN-2010005-03 | 2010Q4 | | Inadequate Procedural Guidance for Heavy Loads Operations |
| 05000454/FIN-2010005-01 | 2010Q4 | | Inadequate Instructions for the Inspection of the River Screen House and Essential Service Water Cooling Tower |
| 05000454/FIN-2010006-01 | 2010Q4 | | Manual Actions Not Explicitly Approved |
| 05000454/FIN-2010006-02 | 2010Q4 | | Failure to Provide Adequate Guidance in Safe-Shutdown Procedures |
| 05000454/FIN-2010006-03 | 2010Q4 | | Failure to Periodically Test 125 Vdc Molded Case Circuit Breakers |
| 05000454/FIN-2011002-03 | 2011Q1 | H.7 | Out of Date/Expired Respirator Cartridges |
| 05000454/FIN-2011002-05 | 2011Q1 | P.5 | Failure to Evaluate the Effects of Dynamic Loads at the CS Discharge Piping |
| 05000454/FIN-2011002-04 | 2011Q1 | | Inadequate Instructions for Measuring ECCS Voids |
| 05000454/FIN-2011002-02 | 2011Q1 | H.7 | Self-Revealed Low Flow to Reactor Containment Fan Cooler |
| 05000454/FIN-2011002-01 | 2011Q1 | | Auxiliary Feedwater Pump Heat Exchanger Configured Incorrectly |
| 05000455/FIN-2011011-01 | 2011Q1 | H.12 | Self-Revealing Failure of the 2A Diesel Generator Upper Lube Oil Cooler |
| 05000454/FIN-2011015-01 | 2011Q2 | | Design of Auxiliary Feedwater System Included Voids in Safety-Related Alternate Suction Flowpaths |
| 05000454/FIN-2011013-02 | 2011Q2 | | Concerns with Licensees Margin to Overfill Analysis Related to Steam Generator Tube Rupture Event |
| 05000454/FIN-2011015-02 | 2011Q2 | H.14 | Failure to Adequately Document and Justify Continued Operability of the Auxiliary Feedwater System |
| 05000454/FIN-2011404-01 | 2011Q2 | H.1 | Security |
| 05000454/FIN-2011009-03 | 2011Q2 | P.2 | EDG Usable Fuel Calculations Failed to Consider Appropriate EDG Frequency Variations |
| 05000454/FIN-2011009-02 | 2011Q2 | H.13 | Failure to Follow Procedure Requirements for Temporary Scaffolds that Remain in Place for Over 90 Days |
| 05000454/FIN-2011009-01 | 2011Q2 | H.13 | Failure to Specify and Perform Required Independent Quality Verification Hold Point Inspections |
| 05000454/FIN-2011003-01 | 2011Q2 | | Failure to Ensure that the Design of the AF Suction Piping was Adequate to Prevent Air Entrainment Following a Seismic of Tornado Event |
| 05000454/FIN-2010502-02 | 2011Q2 | | Changes to EAL Basis Decreased the Effectiveness of the Plan without Prior NRC Approval |
| 05000454/FIN-2011013-01 | 2011Q2 | | Restoring Compliance With Respect to Single Failures |
| 05000454/FIN-2010502-01 | 2011Q2 | | (Traditional Enforcement) Changes to EAL Basis Decreased the Effectiveness of the Plan without Prior NRC Approval |
