05000482/FIN-2013004-03: Difference between revisions
Jump to navigation
Jump to search
StriderTol (talk | contribs) (Created page by program invented by StriderTol) |
StriderTol (talk | contribs) (Created page by program invented by StriderTol) |
||
Line 12: | Line 12: | ||
| identified by = Licensee | | identified by = Licensee | ||
| Inspection procedure = | | Inspection procedure = | ||
| Inspector = N O,' | | Inspector = N O, 'Keefej Laughlin, C Peabody, M Williams, C Hunt, R Stroble | ||
| CCA = N/A for ROP | | CCA = N/A for ROP | ||
| INPO aspect = | | INPO aspect = | ||
| description = Title 10 of the Code of Federal Regulations, Part 50, Appendix B, Criterion V, Instructions, Procedures, and Drawings, states, in part, that activities affecting quality shall be prescribed by procedures appropriate to the circumstances. Contrary to the above, a procedure for an activity affecting quality was not appropriate to the circumstances. Specifically, as of May 6, 2013, Procedure MPE GK-004 GK Unit Preparation for Work, Revision 4, was inadequate to prevent over-tightening of the wing screws on the filter dryer assembly, in that the procedure did not specify how tight to leave the wing screws. This led to failure of the filter drier, pieces of which blocked the thermostatic expansion valves and overheated the Class 1E electrical equipment air conditioning chiller. Using Inspection Manual Chapter 609, Appendix A, Exhibit 2, Mitigating Systems Cornerstone screening questions, Section A, the finding was determined to be of very low safety significance (Green) because only one train of Class 1E electrical equipment was affected and room temperatures remained below maximum limits. This violation was entered into the licensees corrective action program as Condition Report 68818. | | description = Title 10 of the Code of Federal Regulations, Part 50, Appendix B, Criterion V, Instructions, Procedures, and Drawings, states, in part, that activities affecting quality shall be prescribed by procedures appropriate to the circumstances. Contrary to the above, a procedure for an activity affecting quality was not appropriate to the circumstances. Specifically, as of May 6, 2013, Procedure MPE GK-004 GK Unit Preparation for Work, Revision 4, was inadequate to prevent over-tightening of the wing screws on the filter dryer assembly, in that the procedure did not specify how tight to leave the wing screws. This led to failure of the filter drier, pieces of which blocked the thermostatic expansion valves and overheated the Class 1E electrical equipment air conditioning chiller. Using Inspection Manual Chapter 609, Appendix A, Exhibit 2, Mitigating Systems Cornerstone screening questions, Section A, the finding was determined to be of very low safety significance (Green) because only one train of Class 1E electrical equipment was affected and room temperatures remained below maximum limits. This violation was entered into the licensees corrective action program as Condition Report 68818. | ||
}} | }} |
Revision as of 20:49, 20 February 2018
Site: | Wolf Creek ![]() |
---|---|
Report | IR 05000482/2013004 Section 4OA7 |
Date counted | Sep 30, 2013 (2013Q3) |
Type: | NCV: Green |
cornerstone | Mitigating Systems |
Identified by: | Licensee-identified |
Inspection Procedure: | |
Inspectors (proximate) | N O 'Keefej Laughlin C Peabody M Williams C Hunt R Stroble |
Violation of: | 10 CFR 50 Appendix B Criterion V |
INPO aspect | |
' | |