ML20259A214

Defueled Safety Analysis Report, Instructions and Key to Unit 2 DSAR Revision 0

ML20259A214
Person / Time
Site:	Indian Point
Issue date:	09/14/2020
From:	Entergy Nuclear Operations
To:	Office of Nuclear Reactor Regulation
Shared Package
ML20259A199	List: ML20259A200 ML20259A201 ML20259A202 ML20259A203 ML20259A204 ML20259A205 ML20259A206 ML20259A207 ML20259A208 ML20259A209 ML20259A210 ML20259A211 ML20259A212 ML20259A213 ML20259A214 ML20259A215 ML20259A216 ML20259A217 NL-20-066, Engineering Report IP-RPT-11-00032, Revision 5, Licensing Report on the Inter-Unit Transfer of Spent Nuclear Fuel at the Indian Point Energy Center
References
NL-20-066
Download: ML20259A214 (1)

Text

IP2 DEFUELED SAFETY ANALYSIS REPORT Instructions and Key to Unit 2 DSAR Revision 0 Current Changes - Revision 0:

The 2020 revision to the Unit 2 UFSAR is the creation of the Unit 2 Defueled Safety Analysis Report (DSAR), issued as Revision 0. Since it is a major rewrite, revision bars have not been used.

The Technical Requirements Manual (TRM) has been added as Appendix B. It too is Revision 0 as it is a major rewrite, and so does not have revision bars. Sections that have been deleted are indicated by Deleted in the TRM Table of Contents, and the original numbering remains the same.

Historical Information:

The DSAR has some parts marked as Historical Information as defined in NEI 98-03, Guidelines for Updating Final Safety Analysis Reports. Information that is highlighted with a green background is designated as Historical Information and is not updated.

The definition of Historical Information means that the information meets the following criteria:

• Information relating to initial plant licensing and start-up that was included in the original FSAR to meet the requirements of 10CFR50.34(b).

• Information that was accurate at the time the plant was originally built, but is not intended or expected to be updated for the life of the plant (unless required by the Commission).

• Information that is not affected by changes to the plant or its operation.

• Information that does not change with time.

NRC Orders and License Conditions:

Information relocated to the previous UFSAR from the Technical Specifications or included by NRC Order, become a Licensing Condition and cannot be removed from the DSAR without NRC approval. Where these are identified, there will usually be a [Note:] and purple highlighting.

DSAR Figures and Plant Drawings:

The figures from the UFSAR that were retained in the DSAR have not been renumbered -

following the Instructions is a Table titled CROSS REFERENCE, DSAR Figures to UFSAR Figures to be used to determine which UFSAR figure corresponds to the DSAR figure number in the text. Referenced plant drawings are not included in the DSAR. Refer to the most current revision of the official plant drawing in the Electronic Document Management System (IPEC eB Reflib).

Searching the DSAR:

The Unit 2 DSAR is viewed and searched in Adobe Acrobat. The best way to find the information you are looking for is to open the left-hand tab named Bookmarks. This will unfold a built in Table of Contents that has links to the chapter sections, tables, and figures.

Use the binoculars on the top tool bar to search for the information you are looking for. Adobe uses normal Boolean search logic, including the use of the wildcard *.

1 of 1 Revision 0, 2020