ML032801441

Technical Specification Page for Amendment Nos. 237 and 236, Surry, Units 1 and 2, Respectively

ML032801441
Person / Time
Site:	Surry
Issue date:	10/01/2003
From:	Gratton C NRC/NRR/DLPM/LPD2
To:	Christian D Virginia Electric & Power Co (VEPCO)
References
TAC MB6752, TAC MB6753
Download: ML032801441 (1)

Text

TABLE 4.1-1 MINIMUM FREQUENCIES FOR CHECK CALIBRATIONS AND TEST OF INSTRUMENT CHANNELS Channel Descriytion Check 'Calibrate t

1. Nuclear Power Range S D(1,5) Q(2) I) Against a heat balance standard, above 15% RATED POWER Q(3,5) 2) Signal at AT; bistable action (permissive, rod stop, trip)

R(4) 3) Upper and lower chambers for symmetric offset by means of the movable incore detector system

4) Neutron detectors may be excluded from CHANNEL CALIBRATION

5) The provisions of Specification 4.0.4 are not applicable

2. Nuclear Intermediate Range *S R(2,3) P(l) 1) Log level; bistable action (permissive, rod stop, trip)

(below P-10 setpoint) 2) Neutron detectors may be excluded from CHANNEL CALIBRATION

3) The provisions of Specification 4.0.4 are not applicable

3. Nuclear Source Range *S R(2,3) P(l) 1) Bistable action (alarm, trip)

(below P-6 setpoint) 2) Neutron detectors may be excluded fmm CHANNEL CALIBRAITON

3) The provisions ofSpecifcation 4.0.4 are not applicable

4. Reactor Coolant Temperature *S R Q(1) 1) Overtemperature AT Q(2) 2) Overpower AT Reactor Coolant Flow S R Q Pressurizer Water Level S R Q i 7. Prssurizer Pressure S R Q

q. 7 High & Low)

Z 8. 4 KV Voltage and Frequency N.A. R Q(l) 1) Setpoint verification not required

9. Analog Rod Position *S(1,2) R N.A. 1) With step conters NJ 0.

(3) 2) 3)

Each six inches of rod motion when data logger is out ofservice NA. when reactor is in HOT, INTERMEDIATE OR COLD SHUTDOWN I

WA