| | Q | CCA | Title |
|---|
| 05000334/FIN-2010005-06 | 2010Q4 | | 270 Degree Circumferential Flaw Found on Residual Heat Removal System Drain Valve Socket Weld |
| 05000334/FIN-2010005-03 | 2010Q4 | H.9 | Maximum Differential Temperature Exceeded for Spray Nozzle during Pressurizer Heatup |
| 05000334/FIN-2010005-02 | 2010Q4 | H.12 | Failure to Follow Procedure Results in Main Feedwater Piping Pressurization |
| 05000334/FIN-2010005-01 | 2010Q4 | | Premature Lifting of ECCS Relief Valve RV-1 SI-8458 |
| 05000334/FIN-2011002-02 | 2011Q1 | P.1 | lnadequate Spray Additive System Sampling Procedures |
| 05000334/FIN-2011002-01 | 2011Q1 | H.5 | lnadvertent Auxiliary Feedwater Start during Steam Generator Water Level Instrument Adjustments |
| 05000334/FIN-2011007-01 | 2011Q2 | | Failure to Verify the Design Requirements for the Fuel Oil Transfer Pumps |
| 05000334/FIN-2011007-02 | 2011Q2 | | Inadequate Calculations for Placing SSST LTC in Manual Mode |
| 05000334/FIN-2011007-04 | 2011Q2 | | Offsite Power Non-Conservative Post Transient Voltage Calculations |
| 05000334/FIN-2011003-03 | 2011Q2 | | Defective Fuel Injection Pump Supply Lines Provided by the Diesel Engine Manufacturer Results in an Emergency Diesel Generator Being Inoperable |
| 05000334/FIN-2011003-02 | 2011Q2 | P.3 | Failure to timely correct Radiation Monitor deficiencies |
| 05000334/FIN-2011003-01 | 2011Q2 | H.5 | Failure to Maintain Recirculation Spray Heat Exchangers in Chemical Wet Layup |
| 05000334/FIN-2011007-03 | 2011Q2 | | Degraded Voltage Relay Time Delay |
| 05000334/FIN-2011009-01 | 2011Q3 | P.2 | Failure to Implement Effective Corrective Actions to Prevent Recurrence of Socket Weld Failures |
| 05000334/FIN-2011009-02 | 2011Q3 | | Failure to Implement Corrective Actions for 2A Service Water Pump Motor Epoxy Voiding |
| 05000334/FIN-2011403-01 | 2011Q3 | | Security |
| 05000334/FIN-2011403-02 | 2011Q3 | | Security |