ML20154N951

Certificate of Compliance 9089,Rev 9,for Model HN-100S. Approval Record Encl

ML20154N951
Person / Time
Site:	07109089
Issue date:	03/12/1986
From:	Macdonald C NRC OFFICE OF NUCLEAR MATERIAL SAFETY & SAFEGUARDS (NMSS)
To:
Shared Package
ML20154N935	List: ML20154N932 ML20154N951
References
NUDOCS 8603200084
Download: ML20154N951 (4)

Text

. __ _. _______

, - - - - - - - ,x- -, -

cx,---,,xxx axx-a xxx--sxmm.acx,ncx=w nc.ncrm.w .y b

I U.S. NUCLEAR QEGULAToRY COZMISSION F

II N.RC ao FORM 41s CERTIFICATE OF COMPLIANCE I l io CFR " FOR RADIOACTIVE MATERIALS PACKAGES c PACKAGE ICENTtF ACATION NUMBER d PAGE NUMBER e TOT AL NOMgER PAGES I a CERTlFICATE NUMBER D REVIS@N NUMBER g! 9089 9 USA /9089/A 1 3 &

h lf 2 PREAMBLE g- e This Certificate is issued to Certify that the packaging and contents described in item 5 below, meets the apphcaele safety standards set fortn in Title 10. Code I of Federal Regulations. Part 71. " Packaging and Transportation of Radioactive Material" E i

I e This certificate does not reheve the consignor from comphance with any requirement of the regulations of the U S Department of Transportation or other i k-apphcable regulatory agencies including tne government of any country througn or into which the package will be transported l l t

h

'E l !

! F -

• 3 THIS CERTIFICATE is !SSUED ON THE BASIS OF A SAFETY ANALYSIS REPORT OF THE PACKAGE DESsGN OR APPUCATION l' a ISSufD TO r4eme w neem e TITLE AND ICENTIF# CATION OF REPORT OR APPUCATION E

it lg Westinghouse Hittman Nuclear Westinghouse Hittman Nuclear Inc. k lN Corporation Inc. Application dated March 13, 1984, #

E Nl 9151 Runsey Road as supplemented.

f Columbia, MD 21045 f:l 4l e Doc =ET ~ UMBER 71-9089 t O CONOiTIONS

'Ni This certificate is conditional upon fultalbng the requirements of 10 CFR Part 71. as appbcable. and the conditions specified beso*

l 11; _ i lg: f-s eackaging ll (a) i 9

Rl E

{ (1) Model No.: HN-100S E (2) Description f lt-s g The cask is a steel annulus 84-1/4 inches high by 81-5/8 inches in i l

I diameter. The cavity is 75-1/2 inches high by 75-5/8 inches in diameter. :I I

I The side walls consist of two plys of 1-1/2-inch steel . The 3-inch steel base is integrally welded to the cylinder. The lid is a 3-inch l

]{ g steel plate, stepped to mate with the upper flange of the cylinder. A g! centrally located shield plug is similarly constructed. The lid and lgE l plug are attached with stud-bolts and nuts and sealed with Buna N 0- F Hl j ring gaskets. A plugged drain line and/or optional vent / test in the ,E Ni secondary lid connection is provided. Four skewed lugs welded to the

, f outer shell are used for tie down. There are three cask lifting lugs, three lid lif ting lugs, and one shield plug lifting lug. The package 8(

j lg:

f gross weight is approximately 43,000 pounds.

'g a

F

g g!

I (3) Drawings )

l lB The packaging is fabricated in accordance with Hittman Nuclear &

fl g

Development Corporation Drawing Nos.- C001-5-9123, Rev. 5 and C001 !p g, 9129, Rev. 3.

!pH ,

I!

I 'l l 1

4 I !i l l lI i

I I I

I I l I f I I I I I I N2gggy % l I C l l l

I l

ma _ m a m amm axn sas1 m anacmairm a m iMka m mm m KEAM = m dEM_M&MAES Conditions (continued) l Page 2 - Certificate No. 9089 - Revision No. 9 - Docket No. 71-9089 l S. (b) Contents  :

(1) Type and fom of material .

Process solids, either dewatered, solid or solidified, meeting the requirements for low specific activity material .

(2) Maximun quantity of naterial per package.

Greater than Type A quantity of radioactive material which may contain h fissile naterial provided the fissile material does not exceed the g limits in 10 CFR @71.53. The weight of the contents, secondary 95 containers, and shoring must not exceed 17,000 pounds and the internal #

decay heat load must not exceed 2 themal watts.

{

6. (a) For any package containing water and/or organic substances which could radiolytically generate conbustible gases, detemination must be made by (g

tests and neasurements or by analysis of a representative package such that g the following criteria are met over a period of time that is twice the f i expected shipment time:

[

(i) The hydrogen generated must be limited to a nolar quantity that would be no rore than 5% by volume (or equivalent limits for other inflam- [i g

g; nable gases) of the secondary contaiger gas void if present at STP (i.e., no more than 0.063 g-moles /ft at 14.7 psia and 70*F); or 5:

F:

(ii) The secondary container and cask cavity must be inerted with a diluent I to assure that oxygen must be limited to 5% by volume in those portions of the package which could have hydrogen greater than 5%.

f gi E;

For any package delivered to a carrier for transport, the secondary container F:

nust be prepared for shipment in the sane manner in which detemination for Ei gas generation is made. Shipment period begins when the package is prepared (sealed) and nust be completed within twice the expected shionent time. [

g; R,

(b) For any package shipped within 10 days of preparation, or within 10 days ,gi after venting of drums or other secondary containers, the detemination in E Ij A (a) above need not he nade, and the time restriction in (a) above does not a pply.

E

7. Except for close fitting contents, shoring nust be placed between the secondary Ei containers and cask cavity to minimize movement during nomal conditions of ts trans port. El E:

l

8. The lid and shield plug lifting lugs must not be used for lifting the cask, and shall be covered in transit.

fgj I)

9. Packagings without a drain line must be provided within the operational vent / test ,gi connection in the cask secondary lid. E

.E

! 10. The drain line and optional vent / test connection rust be appropriately plugged ar.d sealed prior to transport, y

)

'N lN

u il

__________________________________________.w_______1

...m mammm.s.scawm .isummms.str1Trz emacsfrzarrarmwemgarg CONDITIONS (continued) p Page 3 - Certificate No. 9089 - Revision No. 9 - Docket No. 71-9089 lkl l

4 _

!il k 11. Prior to each shipment, the nackaging lid seals, if opened (or if the security seal is broken), nust be inspected. The seals nust be replaced with new seals if inspection shows any defects or every twelve months, whichever occurs first.

j

12. The packaging must be leak tested at least once every twelve nonths in accordance

. with Leak Test Procedure STD P-02-002, Rev. O, dated February 2,1984. Each cask which has been damaged or repaired in the area of a seal rust also be tested prior to subsequent use; normal gasket naintenance does not require a subsecuent test.

13. Packagings fabricated af ter November 30, 1983, must be constructed of A-516, ~0 Grade 70 carbon steel .

la. The package authorized by this certificate must be transported on a notor vehicle, railroad car, aircraf t, inland watercraft, or hold or deck of a seagoing vessel assigned for the sole use of the licensee.

E 15. The package authorized by this certificate is hereby approved for use under the f general license provisions of 10 CFR Q71.12. p

16. Expiration date: November 30, 1988. h E

REFERENCES l

I.'

Westinghouse Hittman Nuclear Incorporated application dated fiarch 13, 1984.

Supplements dated: April 19,1985; and January 28, 1986.

FOR THE U.S. NUCLEAR REGULATORY C0fif1ISSION M f.

E Q Charles E. f.acDonald, Chief $

() Transportation Certification Branch lg Division of Fuel Cycle and f4aterial Safety, t#1SS g MAR 121986 Date:

1l F R

9 i

E i

N.

E E

i-E jI lp N

! ....- +

1. 'o g UNITED STATES

! o NUCLEAR REGULATORY COMMISSION h E WASHINGTON, D. C. 20555 o I

%...../ Transportation Certification Branch Approval Record Model No. HN-100S Package Docket No. 71-9089 By application dated January 28, 1986, Westinghouse Hittman Nuclear Incorporated requested an anendment to the Model No. HN-100S packaging.

The amendment provides for an alternate drain line material. The old material was A-181 Gr 1 which is no longer available and the new material is ASTM A-105. The new material has ultimate and yield values at least as good as the old material (Fu: 70 ksi vs 60 ksi; and Fy: 36 ksi vs 30ksi).

The change will not effect the ability of the package to meet the requirements of 10 CFR Part 71.

g Charles E. MacDonald, Chief i

Transportation Certification Rranch Division of Fuel Cycle and Material Safety, NMSS Date: M"^

1 l

l l