Regulatory Guide 3.43
| ML13038A433 | |
| Person / Time | |
|---|---|
| Issue date: | 04/30/1979 |
| From: | NRC/OSD, Office of Nuclear Regulatory Research |
| To: | |
| References | |
| RG-3.043, Rev. 1 | |
| Download: ML13038A433 (2) | |
U.S. NUCLEAR REGULATORY
COMMISSION
Revision 1 April 1979 REGULATORY
GUIDE OFFICE OF STANDARDS
DEVELOPMENT
REGULATORY
GUIDE 3.43 NUCLEAR CRITICALITY
SAFETY IN THE STORAGE OF FISSILE MATERIALS
A. INTRODUCTION
Section 70.22, "Contents of Applications," of 10 CFR Part. 70, "Domestic Licensing of Special Nuclear Material," requires that applications for a specific license to own, acquire, deliver, receive, possess, use, or transfer special nuclear material contain proposed procedures to avoid accidental'
conditions of criticality.
This regulatory guide provides guidance for complying with this portion of the Commission's regulations by describing procedures accept-able to the NRC staff for the prevention of criticality accidents in the storage of fissile materials outside nuclear reactors.
B. DISCUSSION
ANSI N16.5-1975, "Guide for Nuclear Criti-cality Safety in the Storage of Fissile Mate-rial, "' was prepared by Subcommittee
8, Fis-sionable Materials Outside Reactors, of the Standards Committee of the American Nuclear Society. ANSI N16.5-1975 was approved by the American National Standards Committee N16, Nuclear Criticality Safety, in 1974 and sub-sequently by the American National Standards Institute (ANSI) on April 12, 1975.ANSI N16.5-1975 is applicable to the storage of fissile materials as metals and oxides. Its applicability is limited to 100 wt-% U-233, ura-nium containing more than 30 wt-% U-235, and plutonium containing more than 80 wt-% Pu-239 (all percentages based on metal content only).The standard presents tabulated mass limits of these fissile materials in storage cells of idealized water-reflected storage arrays.Caution in the use of the tabulated values in the standard is advised to ensure subcriticality
- Lines indicate substantive changes from previous issue.'Copies may be obtained from the American Nuclear Society,"555 North Kensington Avenue, La Grange Park, Illinois 60525.of each storage cell and of the storage array.These tabulated values do not include the effects of moderation by hydrogenous materials contiguous to the fissile materials.
Evaluation of these effects by use of a validated computa-tional technique is recommended in the stand-ard. The standard also presents guidance on reduction factors to be applied to the tabulated mass limits to account for the effects of posi-tion and double batching of fissile material in a storage cell, the reflecting properties of con-crete or other masonry construction materials used in the storage facility, and the proximity of individual storage arrays.C. REGULATORY
POSITION The nuclear criticality safety practices, limits, and conditions for the storage of fissile material and the guidance for other storage configurations contained in ANSI N16.5-1975 provide procedures generally acceptable to the NRC staff for the prevention of criticality accidents in the storage of fissile materials out-side nuclear reactors subject to the following:
1. Use of ANSI N16.5-1975 is not a sub-stitute for detailed nuclear criticality safety analyses for specific storage arrangements for fissile materials.
2. The mass limits tabulated in the standard that are marked by a superscript "a" to show that they exceed 90 percent of the critical mass of a water-reflected sphere should not be used unless it can be demonstrated that their use could not result in criticality under conditions involving errors or accidents such as double batching or water immersion.
3. The tabulated masses in the standard are not acceptable without all of the appropriate adjustments called for by the standard.
License applicants wanting to use the standard should, USNRC REGULATORY
GUIDES Regulatory Guides ae ismued to decicdbe and mie avaisla to the public mnethods acceptable to the NAC staff of 1:lse 'pcfic pats of the Commissio's regulations, to deli netoe n .M d by the staff In owue-aling pA olsm pIssw l o te ad , I to IpovMid guplden to applicants Regulatory Guides we not .stitts for regulaions and ccm-pianc@ with them a not requied. Mehods and solutions dIffe t from thorn sat out in One guidee will be acceptable Nf the provide a basis for the linmbg requioi to th osisance or continuance of a pani or e by tO Cou on.conwtiento andl mjsetalaton tor iWromwernenl In fthse guides wre anorwaged at l11 tirmes nd gAdes wl be rMd, I napproprite, to accommodte conmmm end tlo reflect no hnnetomon or We*n- This qgui roed as a resu of m*,eestiavs commem receive from fth pubc end additional easff revLe.Corment ehouid be .nt to the Secretary of the Cornmison, U.S. Nulear Regratory Commission, Waslhirton, D.C. 20, Attention:
Docke an&W sevce Brench.The gurdes we issued in the followng tn broad divimione:
1. Powe Reector 6. Products 2. Ieseh end Tet Reactora
7. Tranaportation
3. Fusl and Matonals Facilities
8. Occupetional Health 4. Enuonomeled idtSin 9. Antitrust and Financial Review *5. Materials and Plm Protection
10. General RequMs fto snle coapi of esued guides lwhtch rtsy be reproduced)
or for pleosment on an autorneft distribution iet tor single. coie of future gide in FdM divisiorm ouid be mod. in wting to the U.S. Nuclear RoegloryWseeingamn, D.C. 20M, Atterntion:
Directm. D on of Techncl Winf tion ad Document Contol.
among other things, demonstrate that the re-quirements of paragraphs
5.3 through 5.6 of the standard have been met.4. Section 7 of ANSI N16.5-1975 lists addi-tional documents referred to in the standard.The specific applicability or acceptability of these listed documents will be covered separately in other regulatory guides, where appropriate.
D. IMPLEMENTATION
The purpose of this section is to provide information to applicants regarding the NRC staff's plans for using this regulatory guide.The methods described in this guide were applied in a number of specific cases during reviews and selected licensing actions. These methods reflect the latest general NRC approach to criticality safety in the storage of certain types of fissile material outside of nuclear reactors.
Therefore, except in those cases in which the applicant proposes an acceptable alternative method for complying with specified portions of the Commission's regulations, the method described herein is being and will continue to be used in the evaluation of submittals for license applications submitted pursuant to 10 CFR Part 70 until this guide is revised as a result of suggestions from the public or additional staff review.(I'.~zu 0.0 ~a z 0 0 0'0 45 U z 00 z 0.