ML073170339

Survey Unit Release Record EP Rx 126D

ML073170339
Person / Time
Site:	Plum Brook
Issue date:	10/31/2007
From:	Randall D US National Aeronautics & Space Admin (NASA)
To:	NRC/RGN-III/DNMS/DB
References
EP Rx 126D
Download: ML073170339 (13)

Text

Survey Unit Release Record Design # Snwey Unit #(s) Description FSSICharacterization Manager EP-Rx 126D Rx 126D 1) Embedded Pipe (EP) Survey Unit Rx 126D meets the definition of embedded pipe for Plum Brook Reactor Facility (PBRF). 2) EP Rx 126D is a Class 1, Group 2 survey unit as per the PBRF Final Status Survey Plan (FSSP) and Technical Basis Document (TBD)-06-004. 3) Surveys in EP Rx 126D were performed using a scintillation detector optimized to measure gamma energies representative of Cd. Sample #EP2- 2 fiom Survey Request (SR)-13 was referenced for this decision.

4) Survey Instructions for this survey unit are incorporated into and performed in accordance with (IAW) the Babcock Services Incorporated (BSI)/LVS-002, Work Execution Package (WEP)05-006. Survey instructions described in this document constitute "Special Methods" and the survey design used in the acquisition of survey measurements.

5) Instrument efficiency determinations are developed in accordance with the BSVLVS-002, WEP 05-006, these determinations are appropriate for the types of radiation involved and the media being surveyed.

Revision # Original Page 1 of 3

, FSS Design # EP Rx 126D Survey Unit Rx 126D 1.0 HistoryDescription 1 1 The subject pipe system is the 0.75" drain located in room 22 of the Rx building.

1 2 EP Rx 126D consists of 0 75" diameter piping that is approximately 15 feet in length 2.0 Survey Design Information 2.1 EP Rx 126D was surveyed IAW Procedure

1. BSI/LVS-002.

2.2 1W? of the 0.75" ID pipe was accessible for survey The accessible 0.75" ID pipe was surveyed by static measurement at one foot increments, for a total of 15 survey measurements. 2 3 Surface area for the 0.75" ID piping is 182 cm2for each foot of pi in& P corresponding to a total 0.75" ID piping surface area of 2,736 cm (0.3 m2) for the entire length of (approximately 15') of 0 75" piping. 3.0 Survey Unit Measurement LocationslData 3 1 Pipe interior radiological survey forms ate provided in Attachment 2 of this release record.

4.0 Survey Unit InvestigatiodResults 4.1 None 5.0 Data Assessment Results 5.1 Data assessment results are provided in the EPtBuried Pipe (BP) Survey Report provided in Attachment

1. 5 2 All measurement results are less than the Derived Concentration Guideline Level (DCGL) for radionuclide specific EP that corresponds to the 1 mreidy-r dose goal established in Table 3-3 of the FSSP. 5.3 When implementing the Unity Rule, provided in Section 3.6.3 of the FSSP, and applying the Nuclide Fraction 0, provided in TBD-06-004, the survey unit that is constituted by EP Rx 126D passes FSS. 5.4 Background was not subtracted

&om the survey measurements and the Elevated Measurement Comparison (EMC) was not employed for this survey unit Revision # Original Page 2 of 3 Statistical Parameter . . - FSS Design

1. EP Rx 126D Survey Unit: Rx 126D 5.5 Statistical Summary Table 6.0 Documentation of evaluations pertaining to compliance with the. unrestricted use limit of 25 mremlyr and dose contributions from Embedded Pipe and radionuclides contributing 100/o in aggregate of the total dose for both structural scenarios and soils. 6.1 A review of the survey results has shown that the dose contribution for EP Rx 126D to be less than 1 mremlyr. The dose contribution is estimated to be 0.038 mrem/yr based on the average of the actual gross counts measured.

7.0 Attachments Attachment 1 - BSI EPBP Survey Report Attachment 2 -Pipe Interior Radiological Survey Form Attachment 3 - DQA Worksheet Attachment 4 -Disc containing RR for EP Rx 126D & Spreadsheet Revision # Original Page 3 of 3 SECTION 7 ATTACHMENT 1 z PAGE(S)

BSI EPlBP SURVEY REPORT FOll.5L-X 00471 no sled Number of Measurements Abanre DCGL Survey Technician(s)

TBD 06-004 Piping Gmup SR-13 Radionudii Di6bibution Sample Measured Nuclide Area FaotorlEMC Used PassFaa FSS MREMNR Contribution 2 EP 2 COa, No Pass <1 COMMENTS:

ACTIVITY VALUES NOT BACKGROUND CORRECTED RP Engineer I Date I DJ /o-2s-07 <

EP Rx 126D 0.75" Pipe TBD 06-004 Group 2 SECTION 7 ATTACHMENT 2 z PAGE(S)

/ BSYLVSPipeCrawler-002 Revision 4 Pipe Interior Radiological Survey Form Date: 31 1 2 /07 Time: /3 SO Pipe ID#: & 126 D Pipe Diameter:

1. ?sf' Access Point Area: & 2 Z TlZffM Building:

? Elevation:

-2 7 I System: &/WE ~R~P//I/ Type of Survey Investigation Characterization Final Survey p Other / Gross C06O r/ Cs hk Detector ID# / Sled ID# /I L- ~047 1 AID SLED l Detector Cal Date: 111( 107 Detector Cal Due Date: r I/ ok Instrument:

23fOH/ Instrument ID #: 189094t Instrument Gal Date: /-/I -0 7 Instrument Cal Due Date: 14- 0 r+ From the Daily Pipe Survey Detector Control Form for the Selected Detector Background Value 6 , I cpm lr .C MDcktatic CPm Efficiency Factor for Pipe Diameter 0 . 0 00 bq (fiom detector efficiency determination)

MDcstatii, 480s' Is the MDCstatic acceptable?

&&(if:fadjist sample count time and recalculate MOCE&,tic) - I?/% 5 EPZ-'2, Comments:

19lz~lZV C LvtPLrz~.

Pipe Interior Radiological Survey Attachment 3, Page 1 BSYLVSPipeCrawler-002 Revision 4 Pipe Interior Radiological Survey Form (Continuation Form) Pipe Diameter:

WZS" Access Point Area: & 22 p~d Elevation: - 27 I System: I (5 ~~ZJCI~ Package Page 3 Attachment 3, Page 2

SECTION 7 ATTACHMENT 3 I PAGE(S)

DQA Check Sheet Design # Rx 126D Revision # Original Survey Unit

1. Rx 126D Preliminary Data Review' Answers to the following questions should be fully documented in the Survey Unit Release Record Yes No N/A 1. Have surveys been performed in accordance with survey instructions in the Survey Design?

X 2. Is the instrumentation MDC for structure static measurements below the DCGLW for Class 1 and 2 survey units, or below 0.5 DCGLw for Class 3 survey units? X 3. Is the instrumentation MDC for embeddedlburied piping static measurements below the DCGLw ? X 4. Was the instrumentation MDC for structure scan measurements, soil scan measurements, and embeddedfburied piping scan measurements below the DCGLw, or, if not, was the need for additional X static measurements or soil samples addressed in the survey design?

5. Was the instrumentation MDC for volumetric measurements and smear analysis < 10% DCGLw ? X 6. Were the MDCs and assumptions used to develop them appropriate for the instruments and techniques used to perform the survey? 7. Were the survey methods used to collect data proper for the types of radiation involved and for the media being surveyed?

X 8. Were "Special Methods" for data collection properly applied for the survey unit under review? X 9. Is the data set comprised of qualified measurement results collected in accordance with the survey design, which accurately reflects the radiological status of the facilltp X Graphical Data Review 1. Has a posting plot been created? X 2. Has a histogram (or other frequency plot) been created? X 3. Have other graphical data tools been created to assist in analyzing the data? X Data Analysis 1. Are all sample measurements below the DCGLw (Class 1 & 2), or 0.5 DCGLw (Class 3)? X 2. Is the mean of the sample data < DCGLw? X 3. If elevated areas have been identified by scans andlor sampling, is the average activity in each elevated area < DCGk (Class I), c DCGLW (Class 2), or e0.5 DCGLw (Class 3)?

X 4. Is the result of the Elevated Measurements Test

< 1 .O? X 5. Is the result of the statistical test (S+ for Sign Test or Wr for WRS Test) 2 the critical value?

X Comments:

CS-0912 Page 1 of 1 SECTION 7 ATTACHMENT 4 1 DISC