Regulatory Guide 5.2: Difference between revisions

From kanterella
Jump to navigation Jump to search
(Created page by program invented by StriderTol)
(Created page by program invented by StriderTol)
Line 14: Line 14:
| page count = 1
| page count = 1
}}
}}
{{#Wiki_filter:U.S. ATOMIC ENERGY COMMISSIONREGULATORY GUIS DIRECTORATE OF REGULATORY STANDARDSREGULATORY GUIDE 6.2CLASSIFICATION OF UNIRRADIATED PLUTONIUM AND URANIUM SCRAP12/20/72DE
{{#Wiki_filter:U.S. ATOMIC ENERGY COMMISSION
REGULATORY
GUI S DIRECTORATE  
OF REGULATORY  
STANDARDS REGULATORY
GUIDE 6.2 CLASSIFICATION
OF UNIRRADIATED  
PLUTONIUM  
AND URANIUM SCRAP 12/20/72 DE


==A. INTRODUCTION==
==A. INTRODUCTION==
Part 70 of the Atomic Energy Commission'sregulations requires each licensee to maintain materialcontrol and accounting procedures for the specialnuclear material in his possession under license. A keycomponent of such a system is an accurate, measuredmaterial balance. A significant factor in obtaining such amaterial balance is the determination of the quantity ofnuclear material contained in inventories ofheterogeneous scrap. Segregation and identification ofvarious types and classes of such scrap can materiallyassist in the determination of the nuclear materialcontents by providing information necessary for theselection of appropriate measurement methods and forthe correction of measurement results for such things asimpurities, poisons, self-absorption, orself-multiplication. This guide describes acceptablestandard classifications for both plutonium and uranium"cold" scrap to aid in determining material balances.
Part 70 of the Atomic Energy Commission's regulations requires each licensee to maintain material control and accounting procedures for the special nuclear material in his possession under license. A key component of such a system is an accurate, measured material balance. A significant factor in obtaining such a material balance is the determination of the quantity of nuclear material contained in inventories of heterogeneous scrap. Segregation and identification of various types and classes of such scrap can materially assist in the determination of the nuclear material contents by providing information necessary for the selection of appropriate measurement methods and for the correction of measurement results for such things as impurities, poisons, self-absorption, or self-multiplication.
 
This guide describes acceptable standard classifications for both plutonium and uranium"cold" scrap to aid in determining material balances.


==B. DISCUSSION==
==B. DISCUSSION==
Subcommittee Nl5.], of the American NationalStandards Institute (ANSI) Standards Committee NI5,Methods of Nuclear Materials Control, has developedtwo standards for the classification of "cold" scrapcontaining plutonium or uranium. The standard for theclassification of uranium scrap was approved by ANSI in1970. The standard for the classification of plutoniumscrap was approved by the ANSI Board of StandardsReview on July 25, 1972.
Subcommittee Nl5.], of the American National Standards Institute (ANSI) Standards Committee NI5, Methods of Nuclear Materials Control, has developed two standards for the classification of "cold" scrap containing plutonium or uranium. The standard for the classification of uranium scrap was approved by ANSI in 1970. The standard for the classification of plutonium scrap was approved by the ANSI Board of Standards Review on July 25, 1972.C. REGULATORY
POSITION The classifications for plutonium and uranium"cold" scrap contained in the following ANSI standards are generally acceptable and are sufficiently flexible to be applicable to a wide variety of nuclear facilities:
ANSI N15.1-1970
Classification of Unirradiated Uranium Scrap.1 ANSI N15.10-1972 Classification of Unirradiated Plutonium Scrap.''Copies may be obtained from the American National Standards Institute, Inc., 1430 Broadway, New York, New York 1001
 
===8. USAEC REGULATORY ===
GUIDES Copies of published guides may be obtained by request indicating the divisions desired to the US. Atomic Energy Commission, Washington, D.C. 20545, Regulatory Guides are issued to describe and make available to the public Attention:
Director of Regulatory Standards.
 
Comments and suggestions for methods acceptable to the AEC Regulatory staff of implementing specific parts of Improvements in these guides are encouraged and should be sent to the Secretary the Commission's regulations, to delineate techniques used by the staff in of the Commission, U.S. Atomic Energy Commission, Washington.
 
D.C. 20545, evaluating specific problems or postulated accidents, or to provide guidance to Attention:
Chief, Public Proceedings Staff.applicants.
 
Regulatory Guides are not substitutes for regulations and compliance with them is not required.
 
Methods and solutions different from those set out In The guides are issued in the following ten broad divisions:
the guides will be acceptable if they provide a basis for the findings requisite to the issuance or continuance of a permit or license by the Commission.
 
1. Power Reactors 6. Products 2. Research and Test Reactors


==C. REGULATORY POSITION==
===7. Transportation===
The classifications for plutonium and uranium"cold" scrap contained in the following ANSI standardsare generally acceptable and are sufficiently flexible tobe applicable to a wide variety of nuclear facilities:ANSI N15.1-1970Classification of Unirradiated Uranium Scrap.1ANSI N15.10-1972Classification of Unirradiated PlutoniumScrap.''Copies may be obtained from the American NationalStandards Institute, Inc., 1430 Broadway, New York, New York10018.USAEC REGULATORY GUIDES Copies of published guides may be obtained by request indicating the divisionsdesired to the US. Atomic Energy Commission, Washington, D.C. 20545,Regulatory Guides are issued to describe and make available to the public Attention: Director of Regulatory Standards. Comments and suggestions formethods acceptable to the AEC Regulatory staff of implementing specific parts of Improvements in these guides are encouraged and should be sent to the Secretarythe Commission's regulations, to delineate techniques used by the staff in of the Commission, U.S. Atomic Energy Commission, Washington. D.C. 20545,evaluating specific problems or postulated accidents, or to provide guidance to Attention: Chief, Public Proceedings Staff.applicants. Regulatory Guides are not substitutes for regulations and compliancewith them is not required. Methods and solutions different from those set out In The guides are issued in the following ten broad divisions:the guides will be acceptable if they provide a basis for the findings requisite tothe issuance or continuance of a permit or license by the Commission. 1. Power Reactors 6. Products2. Research and Test Reactors 7. Transportation3. Fuels and Materials Facilities 8. Occupational HealthPublished guides will be r ev.ted pariodicaliy, as appropriate, to accommodate 4. Environmental and Siting 9. Antitrust Reviewcomments and to reflect new informatior o, experience. 5. Materials and Plant Protection 1
3. Fuels and Materials Facilities  
8. Occupational Health Published guides will be r ev.ted pariodicaliy, as appropriate, to accommodate  
4. Environmental and Siting 9. Antitrust Review comments and to reflect new informatior o, experience.


===0. General ===
5. Materials and Plant Protection
}}
10. General}}


{{RG-Nav}}
{{RG-Nav}}

Revision as of 07:17, 26 July 2018

Classification of Unirradiated Plutonium and Uranium Scrap
ML12243A290
Person / Time
Issue date: 12/20/1972
From:
US Atomic Energy Commission (AEC), Office of Nuclear Regulatory Research
To:
References
RG-5.002
Download: ML12243A290 (1)


U.S. ATOMIC ENERGY COMMISSION

REGULATORY

GUI S DIRECTORATE

OF REGULATORY

STANDARDS REGULATORY

GUIDE 6.2 CLASSIFICATION

OF UNIRRADIATED

PLUTONIUM

AND URANIUM SCRAP 12/20/72 DE

A. INTRODUCTION

Part 70 of the Atomic Energy Commission's regulations requires each licensee to maintain material control and accounting procedures for the special nuclear material in his possession under license. A key component of such a system is an accurate, measured material balance. A significant factor in obtaining such a material balance is the determination of the quantity of nuclear material contained in inventories of heterogeneous scrap. Segregation and identification of various types and classes of such scrap can materially assist in the determination of the nuclear material contents by providing information necessary for the selection of appropriate measurement methods and for the correction of measurement results for such things as impurities, poisons, self-absorption, or self-multiplication.

This guide describes acceptable standard classifications for both plutonium and uranium"cold" scrap to aid in determining material balances.

B. DISCUSSION

Subcommittee Nl5.], of the American National Standards Institute (ANSI) Standards Committee NI5, Methods of Nuclear Materials Control, has developed two standards for the classification of "cold" scrap containing plutonium or uranium. The standard for the classification of uranium scrap was approved by ANSI in 1970. The standard for the classification of plutonium scrap was approved by the ANSI Board of Standards Review on July 25, 1972.C. REGULATORY

POSITION The classifications for plutonium and uranium"cold" scrap contained in the following ANSI standards are generally acceptable and are sufficiently flexible to be applicable to a wide variety of nuclear facilities:

ANSI N15.1-1970

Classification of Unirradiated Uranium Scrap.1 ANSI N15.10-1972 Classification of Unirradiated Plutonium Scrap.Copies may be obtained from the American National Standards Institute, Inc., 1430 Broadway, New York, New York 1001

8. USAEC REGULATORY

GUIDES Copies of published guides may be obtained by request indicating the divisions desired to the US. Atomic Energy Commission, Washington, D.C. 20545, Regulatory Guides are issued to describe and make available to the public Attention:

Director of Regulatory Standards.

Comments and suggestions for methods acceptable to the AEC Regulatory staff of implementing specific parts of Improvements in these guides are encouraged and should be sent to the Secretary the Commission's regulations, to delineate techniques used by the staff in of the Commission, U.S. Atomic Energy Commission, Washington.

D.C. 20545, evaluating specific problems or postulated accidents, or to provide guidance to Attention:

Chief, Public Proceedings Staff.applicants.

Regulatory Guides are not substitutes for regulations and compliance with them is not required.

Methods and solutions different from those set out In The guides are issued in the following ten broad divisions:

the guides will be acceptable if they provide a basis for the findings requisite to the issuance or continuance of a permit or license by the Commission.

1. Power Reactors 6. Products 2. Research and Test Reactors

7. Transportation

3. Fuels and Materials Facilities

8. Occupational Health Published guides will be r ev.ted pariodicaliy, as appropriate, to accommodate

4. Environmental and Siting 9. Antitrust Review comments and to reflect new informatior o, experience.

5. Materials and Plant Protection

10. General