ML20235W672
| ML20235W672 | |
| Person / Time | |
|---|---|
| Site: | 07109019 |
| Issue date: | 09/29/1987 |
| From: | GENERAL ELECTRIC CO. |
| To: | |
| Shared Package | |
| ML20235W644 | List: |
| References | |
| NUDOCS 8710160353 | |
| Download: ML20235W672 (9) | |
Text
_ _ _
GENERAL $ ELECTRIC O
l l
I
\\
l l
ATTACHMENT 2 PAGE CHANGES TO THE 12/22/86 BU-7 SHIPPING PACKAGE SUBMITTAL.
THESE REPLACEMENT PAGES ARE IDENTIFIED AS REVISION 2.
O pataanBliTu'
_e
L E: -
w-.
s
- y.
5.0 OPERATING' PROCEDURES, ACCEPTANCE TESTING AND MAINTENANCE L
fPROGRAM 5.1-OPERATING PROCEDURES
- The following procedures represent the ' activities involved in loading - the BU-7 package.
5.1 1' Priorf to placing the ' three or five gallon. pails in the q
BU-7's. inner drum, the pails are inspected.
This inspection ' incl udes :
o. Physical integrity (no holes, broken seals, or cracks) o No excessive ' rust o
Proper fitting lids e
No dents great.er than 1/2 inch deep I
o Unbroken tampersafe seals are in place l
5.1.2 Prior to loading, BU-7 inner drums are inspected to i
assure:
i
+
o There are no visible cracks J
o There is no visible moisture inside container 1
o Inner drwn gasket surfaces are visibly clean, smooth and flat with no holes except bolt holes j
LICENSE SNM-1097 DATE 09/29/87 PAGE
(~ }]
DOCKET 71-9019 REVISION 2
15 -
)
a u y-
'I wb 1
r cV, 1
o'
' Inner ~ drum is visibly : clean, cpainted, and.withL no' l [\\_/
^
~
1 rust spots larger. than 1. square inch o
Ii 01 Bolts or studs are in good condition o'
Inner container cover is clean, flat, dry, painted,
no rust. spots larger than one square inch, and gasket 1 f
surf ace visibly smooth. and flat 5.1.3-Prior to loading BU-7, outer drums are inspected to assure:
o Exterior. paint' is in good condition o
Container is durably marked o:. There are no visible. holes, punctures, or cracks
~
(~{
o Closure rings and bolts are in good condition o
The four 1/4 inch holes are covered from the inside
-with water-proof tape I
o No visible dents greater than 1/2 inch deep i
o Phenolic Foam plug in good condition i
o Outer drum cover in good condition with no holes or cracks LICENSE SNM-1097 DATE 09/29/87 PAGE
' DOCKET 71-9019 REVISION 2 '
}.
N q.
Q' l
~BU-7. drums are packed as follows:,
5.1.4-
.:l, -j !
U o
Three 3-gallon-or two 5-gallon. pails are placed in' side inner' drum h
.l
\\
l c..
'o Place gasket in position o
Bolt inner; 1id..in po'sition. using ' a minimum torque of 12.5 ft. lbs.
L o-Insert insulation plug
'o.
Install cover and secure. closure ring with bolt and
~
nut'
.i
'o-Affix tampersafing seal to the~ bol't o.
The maximum. weight of material per drum is. verified.
.',O
' Limits are based upon the' quantities authorized by.-
' wr.
the certificate of compliance.
I 5.2 ACCEPTANCE TESTING i
The following represent the tests or inspections that are performed prior to the first use' of packaging :
i l
l LICENSE SNM-1097 DATE 09/29/87 PAGE DOCKET 71-9019 REVISION 2.
m
-_-__i_____._.____m.
_, y i
i
'J=
79 f{l c 5. 2 ' 1.,
Inspection Criteria
~
y~D.,..
,^'
Typical Typical
,)
Container Characteristic' Inspection Specifications
. Phenolic Plug-
_15 lbs. ' minimum ~ weig ht of Pl ug Submerged bubble pressure 15' PSIG' minimum I
test for the inner container.
Leak tightness is verified by a submerged bubble pressure test at115.0 PSIG, minimum.. Submersion : time is one minute minimum.
Test is conducted using the silicone rubber container gasket 'as the only seal'ing j()
agent, between' flange and Cover.
Verification of Based on approved f
container measurements dimensions on licensed drawing Appearance integrity No visible holes or cracks, (Visual) and no significant absence of paint.
'5.2.2 Failures are rejected and, where appropriate, reworked and retested.
p l
LICENSE
.SNM-1097 DATE 09/29/87 PAGE
. {}
DOCKET 71-9019 REVISION 2
18 -
l 1
---_.1L__-
y y
n =J
", 93 15.3
< MAINTENANCE' ' PROGRAM Th'e' BU-7. outer drum. and cover are inspected - to. assure :
5.3.1-
~
)
Good adherence -'of L paint o
o ' No ' visible holes? or cracks in ' the metal surf aces-No 'dentsiwhich affect drum integrity o
o.
Closure ) rings and bolts are in good condition-Therfour 1/4 Linch holes l'n sides near top of drum are -
o covered with' weatherproof. tape o.
Phenol'ic ' foam insulation! plug is in serviceable.
J"
. cond ition
()
o. Container'is appropriately marked' a
5.3.2>
The BU-7 inner drum and lid are ' inspected to assure:
'1 1
b o
Inner drum, is visibly' clean and painted j
o Inner drum gasket sealing surf ace is clean, smooth and flat y_
L LICENSE SNM-1097 DATE 09/29/87 PAGE
(])
. DOCKET 71-9019 REVISION 2
19 -
l i.
,a.
3:
e A new-gasketEis used', orithe existing gasket ~ is o:
replaced with a.new gasket-i'f inspection shows any -
defects.. An installed gasket' wil1~be replaced with a L.
' new 'g asket every twelve. months.
I o
Threads are in good condition o.
There is no visible indication of holes-ie 5.4 Replacement Schedules Containers, or:their components.or subsystems, are replaced, on an.as-needed basis, when they do not meet-the' inspection-criteria.
l' l'
5.5 Criteria for Repair of Components and Subsystems Outer container and' inner ' container covers are replaced
()
-when they.will not meet inspection criteria.- Inner gaskets are replaced every 12 months, or ~ sooner. if found damaged when inspected.
Phenolic foam insulation plugs are. replaced if found. damaged when inspected.
Damag ed or deficient 1 bolts and nuts are replaced at inspection during the packir.g process.
i i
l l
l
)
LICENSE SNM-1097 DATE 09/29/87 PAGE
(
DOCKET 71-9019 REVISION 2.
___m
Y'
~
O.
'&,'s
\\,
- ,p l,
,u ljlT o
. 6.0; BU-7 TRANSPORT PACKAGE SPECIFICATIONS
.F
'Specificat' ions for the BU-7 transport package are~ shown
- on, General Electric Drawing 112D1592 in Appendix A.
' Ii,. y f
I e
l i
' LICENSE SNM-1097 DATE 09/29/87 PAGE
-]
DOCKET 71-9019 REVISION 2
- 21 t
i YL_-_:_=_= _ :__ _
7 0
1
. M.
- 4
- m.. _.. _.
....,w g.
- l1 7
/
- p p : eez O
__-