ML20151N380
| ML20151N380 | |
| Person / Time | |
|---|---|
| Site: | 07109222 |
| Issue date: | 08/03/1988 |
| From: | Macdonald C NRC OFFICE OF NUCLEAR MATERIAL SAFETY & SAFEGUARDS (NMSS) |
| To: | |
| Shared Package | |
| ML20151N365 | List: |
| References | |
| NUDOCS 8808080200 | |
| Download: ML20151N380 (4) | |
Text
l m-----_--------
I wie Ec ste U.S. NUCLEAR REcULATORY CO"MISSloN N
CERTIFICATE OF COMPLIANCE J
m 1
'o cra "
FOR RADIOACTIVE MATERIALS PACKAGES a P^os 'wna
- 'o ~ ~ "*P ucta g e.wua
=arwse y ua e ra g g g g i e - Ea 3
3 l
P 1
catwea a Tni. c.n.uc.i.
iou.o io c.rtity tn.t in. p.ca.a no.no conient. o cne.o in ei.m s beio. m
- t. in..ppoc.bw i.a'.t r it.no.ro* *.t 'ortn en T' tie t o cod.
I I
l oi 5.o.r.i n.cui.t.on.. p.n n. e.ck.gina no Tr.nsport i on or n.oio.ci,v. u i.n i.-
I l
ex This c rttic.t. ooe. not r.sim ine cons.onor from cornphance with.ny r quer m.nt of ine regui.uon. of ene u s. D.p.rtment of Transpon iion or otn.r I
1
.ppace. e.gutatory.g.nc
. inciuo.as in. govemm.ni of any country throuon or 6nto wtuch the p.ek.a. =H t* tr.nspon*
3 1
1 1
3 1
1lI
- T'esE!Io3',US'ESm""'"" "'"**'"."'ML*EIn*F,cft!J'8Ed" t oaS*cata I
1 8
I lHittmanNuclear Hittman Nuclear application dated i
1256 North Church Street December 14, 1987, as supplemented.
p i
l Hoorestown, NJ 08057 I
f
, Q, W f1-9222
'OYe.t. i. conen.on.i upon turreme me ed M or io cra een n. as appocei...nline creion. w+cm beo -
d*(a) 9 4
i I
Packaging q.
p ll l
I 3.-
1 (1) Modelho.: M-215H
/'
' /-
y 1
,,7
<g, s
,M y y
(
(2) Degription
]
/f
(*;
I i s 1
Steel encased lead shielded, cask for low specific activity material.
b s
I The task is a right circular. cylinder with a 77.25-inch 10 by 80.25-inch l
j IH cavity. (The outside' diameter of.the cask is 83.5 inches with a g
l 92.25-inch height.JThe walls of-the cask contain a lead thickness of I
g t!
1.88 inches' encased 'in 'O.38-inch thick ' inner steel sh611 and 0.88-inch I
l thick outer 4 teel shell,- phe top cover and, cask bottom are made up of l
1 two pteel plates with. thickness of 2.0 inches.' Theyrimary cask lid is secured to the 'cylindhical icask'boc'y by:eight,1-1/4-inch rachet l
j binders., A secondary lid';fs centered.in the primary "lid and is secured g
to the' primary lid with ieight, '3/4-indh studs and' nuts.
Each lid is a
provided41th a Neoprene 'gasketheal. l'he cask'is\\provided with a 12 I
J gauge stainless steel liner'(seal welded algng'all edges), a lid vent I
l line with pipe glug, and a 3/4-inch drain line and pipe plug. The cask is provided wi'th four equally spaced 1Nting/ tie-down devices. The
{
primary lid is prondedy'itQ.hree:JiftAng lugs and the secondary lid is a
t j
provided with one lifti6g lup Th'e cask gross weight is 58,400 pounds.
l I
j (3) Drawing l
j The package is fabricated in accordance with Hittman Nuclear Drawing l
No. STD-02-077, Sheets 1 and 2, Rev. 6.
l l
l 9
l 1
I t
J I
ggpS0$$h ih I
C 8
1 l
l l
.-------_----------------------------------------i.
l
y__'__________________________-_--------------------- - (
conomous teontinues)
- Page 2 - Certificate No. 9222 - Revision No. 1 - Docket No. 71-9222 l
l 5.
(Continued) l (b) Contents (1) Type and form of material (i) Dewatered, solids, or solidified waste, meeting the requirements h
for low specific activity material, in secondary containers; or I.
(ii) Activated solid epmponent!Drnfeting{the requirements for
(
specific acti y Aateriah 4n hec pa y containers.
(2) Maximum qua ty material per package f
Greater than Type A quantity of radioactive material which may contain l
l fissile material provided the fissile material does not exceed the L
l limits in W CFR 671.18 and 971.22.
oad is limited to f
The decay heat')4 1
9 watts
'b j~
[
'w &N L!. !
?J l
6.
(a) For any package containing Water and/or organi ' substances #hich could
(
l radiolytically generate combustible gases, determination must be made by I
l tests and measurements or by' analysis of a\\ representative package such that
[
~
j the following criteria are. met over,a' period of time that is twice the t
J expected shipment time:
L-
,f y
L i
c.
.,..3
~
l (1) The 5ydrogen generated must be ' limited to a molar ~ quantity that would be i
j no more than 5% by volume,(or equivalent limits for other inflarxnable I
gases) of the secondary cogtainer. gas void if present at STP (i.e., no
(
l more than 0.063 g-moles /ft sat 14.7 psia.and 70'F); or j
.1 (ii) The secondary contain\\er a'nd cask cavity taust be inerted with a diluent i
(.,
(
i to assure that oxygen must be. limited to 5% by volume in those portions i
of the package which could have hydrogen greater than 5%.
[
l For any package delivered to a carrier for transport, the secondary container
[
l must be prepared for shipment,in the same manner in which determination for
[
I gas generation is made. Shipment period begins when the package is prepared i
l (sealed) and must be completed within twice the expected shipment time,
(
I l
)
(b) For any package shipped within 10 days of preparation, or within 10 days
[
l after venting of drums or other secondary containers, the determination in L
(a) above need not be made, and the time restriction in (a) above does not t
apply.
r j
jl l
h 7.
Maximum gross weight of the contents, secondary containers, and shoring is limited L
to 20,000 pounds.
[
i 3
f l
i 1
I l
.....-.--_.----------------___----___-----4
l y.-----
... i"
- vsru;w m wcc" m
s conomons ccontinuem l Page 3 - Certificate No. 9222 - Revision No. 1 - Docket No. 71-9222 I
8.
Except for close fitting contents, shoring must be placed between secondary containers and the cask cavity to minimize movement during normal conditions of transport.
l 9.
The lid and shield plug lifting lugs must not be used for lifting the cask, and must be covered in transit.
l 10.
In addition to the requirements of Subpart G of 10 CFR Part 71:
I Prior to each shipment, the. pay 1sagi iQ The seals must be rep %gd jdti hew s'e$2forrene lid sea (a) la HsMf[ifspection shows any defects er every twelve (12) s %,nichever occurs first. J.avity drain and vent Alth appropriate sealant appfydf'o the pipe plug lines must be se 1 threads.
(b) The package s il be prepared foc shipment and operate ccordance with the Operating Prgcedur'(sw Section 7.0 of the applica.tionf
,}
(c) Eachcaskkstmeeth cttptance Tests and4 kIeanceP ram of Section f
8.0 of the application.
Ih4#dition,;tnerask must be leak teste at least every I
twelve (12) months in accofdance with Paragraph' 8.1~.3 of the application.
I l 11.
4 t4!/
7:
1
\\ L: 1 L'
[
l The cask body aiid each <ask;.lydust Vehrked -in accordance with 40 CFR $71.85(c).
[
I
.. %%C-W'
/
[
The packages authorized by this certificate ~liriust be -transported o,'n a motor o,
f 12.
vehicle, railr'oad car, iircraf tMohnd-wate'rcraf t, or hold'or deck of a seagoing i
I vesselassigned4crthp$i5-&
ole use p Ricensee.
f'f y N
I L';
J i i [j,L(iIeie,by ' approved for use under the h
.A 13.
The package authg'rized by 4hlWe14.
cate ts j
general license pgovisions' of 1( CF3 l p.12. } 4 ;aj
,C;;
{
t l 14.
Expiration date: Febr,uary 28,1993. %N, g'
()s
[
REFERENCES HittmanNuclearapplicationdatedDhcedgrh*1 7.'g'
[
p,.
j Supplement dated: January 26, March 25, and June 10, 1988.
[
FOR THE U.S. NUCLEAR REGULATORY COMMISSION I
L L
L f
(
Charl s E.
acDonald, Chief f
Transportation Branch Division of Safeguards and Transportation, HMSS
(
AUG 0 31988
(
l l Date:
(
l f
f i
,-s----------------------------------------t
\\
- 'e p
f reau UNITED STATES i
fy NUCLiiAR RCGULATORY COMMISSION E
,g WASHINoTON, D C. 20555 g
Transportation Branch A) proval Record Model io. HN-215H Package Docket No. 71-9222 Revision No. 1 By application dated June 10, 1988, Hittman Nuclear requested that Certificate of Compliance No. 9222 be amended to cite Revision No. 6 of the packaging drawing. The drawing was revised to provide for optional guide pins for the primary lid; modifications to the ratchet binder handle storage bracket; and provisions for the installation of landyards to be used to retain such things as lug covers, ratchet binder pins, etc.
f t the ability of the package to meet the equ re en i 10 Part 71
$x l&
Charles E. MacDonald, Chief Transportation Branch Division of Safeguards and Transportation, NMSS Date:
_ _ _ -