ML20126M453
| ML20126M453 | |
| Person / Time | |
|---|---|
| Site: | 07105971 |
| Issue date: | 07/19/1985 |
| From: | Macdonald C NRC OFFICE OF NUCLEAR MATERIAL SAFETY & SAFEGUARDS (NMSS) |
| To: | |
| Shared Package | |
| ML20126M428 | List: |
| References | |
| NUDOCS 8508010359 | |
| Download: ML20126M453 (4) | |
Text
.,,s p------mmm========*==========--------------------------,
! h Ponas eis U.S. NUCLEA'l RE1ULATORY CCMMISSl%N h
CERTIFICATE OF COMPLIANCE I
+asi l
to CFa r' FC"1 RADICACTIVE MATERIAL 3 PACKAGES
!E u
'g j
1 a CEATJFICATE NUMBER b REVISION NUMBER C PACKAGE IDENTIFICATION NUMBER d PAGE NUMBER
. TOTAL NUMBER PAGES j j!
5971 5
USA /5971/B( )F 1
3
!g I
- 2. PREAMBLE N
1
- a. Tnis eerneicare is issu.o to cerney inat in packaging ano contents a seno.o m item s o.4o.. m..ts in.appucsoi. sat.iy stanoaros s.t iortn in Titi. to. coo.
- N
{1 n
j of Federal Regulations. Part 71. Packaging of Radsoactiv. Mat.nais for Transport ano Transportation of Aadioactiv. Material Uno.r Certam Conoitions "
1 o Tnis certivicar. oo.. not ren.
in. consignor from compnanc..itn any mau rement or in. reguianons of in. u s. o.partment or Transportanon or otner
!n h
1 apeticani. r.guiatory agene. meiuoing in. government oe any country enrougn or into.nicn in. pac *ag...ii n. transport.o.
1!
i f
!N 1
g
- 3. THIS CERT 1FICATE IS LSSUEO ON THE BASIS OF A SAFETY ANALYSIS REPORT OF THE PACKAGE DES 4GN OR APPLtCATION g
a PREPARED BY (Nam. and Addresar D TITLE ANO IDENTIFICATION OF REPORT OR APPLICATION 1
General Electric Company General Electric Company application dated ln f
P.O. Box 460 May 30, 1985.
- B
)f
- l Pleasanton, CA 94566
- )
i m
l9 1
m 1
- c_OOCxEbuMBER C 471-5971 R
s v 3aCONOiTiONS
@N 1!
rn.. c rtivicat... eonoinonai upon ruitisiing in. r.aud.m.nts oe to cra Part ri. as appocani.. ano tn. canaitions so.civiao noio.
1
- 1 5
x)
]
(a)
Packaging d'c ~
N
');)
(1) Model 50.: '200 ju 1
,1 i
~
j)
- t (2) Description
'll 3
}j A steel encased lead shielded shipping cask.
The cask is a double-lg walled steel' circular cylinder ~,~20-1/4-inch diameter-by 53 inches high
!y
- )
with a central' cavity 7-5/8-inch diame.ter by 37 inches high.
Approx--
ll 1
imately 5-7/8 inches of lead surround the central cavity. The cask is
'I 1
equipped withia, cavity drain line and lifting device.
Closure is lN
@j
, j) accomplished by a silicone ' rubber gasketed and bolted steel lead filled' plug.
For additional shielding, lead-filled stainless steel
!)
liners may be inserted in the cask cavity.
A protective jacket
- g a
consisting of an upright circular cylinder with -open bottom and a
!p 1
protruding box section diametrically across the top and vertically
!N l ;1 down the sides ~ attaches to a square pallet.
Dimensions of the protective )
d, Jacket are 65-3/8 inches high by 37-5/8 inches wide across the box section.
The outer cylindrical diameter is 26-3/4 inches and the j
j Jai pallet is 47-1/2 inches' square. 'The maximum weight of the packaging ig l j is approximately 10,000 pounds.
!g l 1
!N
! 1 lN i T k
]
!N 1
'N l 1 N
- )
H l 1 il l 1
)
1 lg 1
4 1
8500010359 850719 p
i
=
!g
, ; L
'C PDR lg l
N l -l
.I l
tu
!N
>N i
II l
!N
=
.,..'..,.',,,.,,.,,..,,,,,,,,,,,,..,,,,,,z.,
~
? " " "'
conomous (continues >
I n
Page 2 - Certificate No. 5971 - Revision No. 5 - Docket No. 71-5971 lg i
h I
!g I
5.
(a)
Packaging (continued) lN l
!N i
]l (3) Drawings j
I g
lg The packaging is constructed in accordance with the following General g
ju Electric Company Drawing Nos.:
g i
!N
- I 12904756, Rev. 1 12904758, Rev. I
!N 12904757, Rev. 0**
12904759, Rev. 0*
!W l
lI
- N h
- All components are to be considered safety related.
f ll
- Item 14 must be 47.5"x4"x1" lg II
.e O~m lI (b) Contents
}j c h D C b (f, (1) Type and fonn,.o(naterial 9, -
j y
Q g
ll (i) Byproduct and special nuclear materialiin the fom of fuel rods, lp{
1 W
or pla~tes, fuel assemblies, or meeting the requirements of special
's fohi~ radioactive material; or
'?
R n
{N
'j W
(ii) [;SaTid nonfiss-ile irradiated me:aldiardware,'riactor
( bl ad es ), "a ndi rea ct o r_ s ta rt-u pr'sou rce s.
O g
r,4 ')
Y a
1; -
y (2) Maximum quantity of' mateiral per package; V
ji gt (N < ~ a,./ j, 5 m
jy 4
Radioactive 'decayt eat.not to exceed;780 wat'ts and!500 grams U-235 J
h I
l equiva;1ent mass.
(U '235~equiW1ent'msss, equals U-235 mass plus 1.66 il!
timei'U-23Kmass/plus01!66' times (Pu' mass.),,
e A
W>
5%81jjsi A
/
!g Plutorrflim in excess.ot tw'enty,(20)(curies per package must be in the gl fom of, metal,= metal, alloy,, or reactor' elements:/
i; v
u
-i
.c 1:
m J (*
)!
(c) Fissile Class h,
')
II'
/n
~ Contents 5.(b)(1)(1)-
lh Minimum transport'index to be shown on label b
Y k ",k' ] 7 2.3 y
6.
Shoring must be provided to minimize movement of contents during accident conditions of transport.
lg lE I
7.
At the time of delivery of the loaded package to a carrier for transport, the ly package contents must be dry and the fissile material unmoderated (H to X atomic N
ratio less than 2).
lI l
8.
Prior to each shipment (except for contents meeting the requirements of special
)
fom radioactive material), the pachge mus3 be leak tested by a method capable lg of detemining that a leakage of 10 atm cm /s at standard temperature and
)
pressure in not exceeded.
j
]
9.
Prior to each shipment, the silicone rubber lid gasket.must be inspected. This gasket must be replaced if inspection shows any defects or every twelve (12) lb months, whichever occurs. first.
Cavity drain line must be sealed with appropriate p
- j sealant applied to threads of pipe plug.
>k
y,-a----------------------------------------------mm.----=q pa
-g
~ '~
.l CONDITIONS (continuid) lp
,KI 1
4h
!I Page 3 - Certificate No. 5971 Revision No. 5 - Docket No. 71-5971 lE
=M
'g 1
E
'h) p 1
-4 3
- M 10.
Packaging must be maintained in accordance with Chapter XVII, Cask /Fireshield
- h Maintenance, in Enclosure E of General Electric Company's application dated
- B1 November 15, 1984, as cited in Certificate of Compliance No. 5980.
l{
j
- ti 1
- g 11.
Fabrication of additional packagings is not authorized.
- pj li
,hl 8
- 12. The package authorized by this certificate is hereby approved for use under the it:
4 general license provisions of 10 CFR 571.12.
- i
-1 k
- 3!
13.
Expiration date:
July 31, 1990.
(
1 m
nrm j~
c,Q g 6 O C ( j {mj, f
lg M
s 1,
e \\, '
REFERENCE D'
F 1l s NJ l9 f
General Electric Compangp' plication dated flay 30, 1985.
FOR THE U.S. NUCLEAR. REGULATORY C0fEISSION
- p 4'.
gi v7
- 1!
'4j fg l>h 1'
4 s
G L f
3 i ()
O ~ '
"}J.;
j m.,, Cha rles :E.;ttacDona
,1 Chief ijj q
L Es W Transpor.tation Certification Branch p
^
9 1'
Divisicn:of Fuel Cyele and M
4 q
~
4 q
U) g/
,f Ii i i !. Material Safety, tNSS H
!h
>44 q
II E O lI E
4 Date:
u p
p
,s
~
- p
- )
- .s 4
l>
71
/
{l
- p
,4 s
p p
7 lE lE q
'1 i
lj j;
..q, y
e p!
!k 9
F, p!
lP; p
el E!
.P 1p is o
- s a
.n f1 l>
- k q;
lF 1
!b h
lp 9
- h 1
in I.
le t
la P
1 F1 p
f1 fl g_--------------------------------------.m
8 UNITED STATES
[
- ]6 NUCLEAR REGULATORY COMMISSION 37 3 E WASHINGTON, D. C. 20555 v
i
\\,,
Transportation Certification Branch Approval Record Model No. 200 Package Docket No. 71-5971 By application dated May 30, 1985, General Electric Company requested renewal of Certificate of Compliance No. 5971 for the Model No. 200 (fonnerly GE-200) packaging. A consolidated application was submitted which incorporated the consolidated application of February 20, 1980, and all pertinent supplement information.
A review of the consolida' ed application confinned that all pertinent t
supplement information along with the application of February 20, 1980, has been incorporated into the consolidated application.
The application has been expanded to include a section on operating procedures which covers both dry and wet loading and unloading operations.
The applicant has also revised two of the packaging drawings to show an optional silicone gasket detail. This same gasket detail is authorized by Certificate of Compliance No. 5980 for the Model No. GE-600 packaging.
The consolidated application does not contain a maintenance program.
The applicant's letter of May 30, 1985, states that the maintenance program contained in.the Model No. GE-600 application (Docket 71-5980) are generic and applicable to the Model No. 200.
The consolidated application makes no specific reference to the Model No. GE-600 maintenance program.
Therefore the certificate of compliance has been conditioned to require the Model No. 200 packaging to be maintained in accordance with the specific maintenance program cited by the condition.
The applicant has stated that they do not currently plan to obtain new packagings and for this ' reason, the consolidated application does not address the requirements of 10 CFR 671.85. The certificate of compliance has been conditioned to preclude the fabrication of additional packagings.
The certificate of compliance has been further conditioned to require leak testing of the package prior to each shipment for authorized contents other than contents meeting the requirements of special fann radioactive ma terial.
Based on the staff's review of the consolidated safety analysis report and the conditions stipulated in the certificate of compliance, the staff concludes that the requirement for renewal of the certificate of compliance has been satisfied.
14M Charles E. MacDonald, Chief Transportation Certification Branch c Division of Fuel Cycle and Material Safety, NMSS Date:
AL.191915