ML19291C362
| ML19291C362 | |
| Person / Time | |
|---|---|
| Site: | 07109111 |
| Issue date: | 01/03/1980 |
| From: | Macdonald C NRC OFFICE OF NUCLEAR MATERIAL SAFETY & SAFEGUARDS (NMSS) |
| To: | |
| Shared Package | |
| ML19291C358 | List: |
| References | |
| NUDOCS 8001240281 | |
| Download: ML19291C362 (3) | |
Text
.
Form NRC418 U.S. NUCLEAR REGULATORY COMMISSION CERTIFICATE OF COMPLIANCE 10 C R 71 For Radioactive Materials Packages 1.(a) Certificat Nu ber 1.(b) evision No.
1f) P d ntification No.
1.(d) Pages No. 1 (e) Total Ng. Pag
- 2. PREAMBLE 2.(a)
This certificate is issued to satisfy Sections 173.393a,173.394,173.395, and 173.396 of the Department of Trar sportation Hazardo Materials Regulations (49 CFR 170189 and 14 CFR 103) and Sections 146-19-10a and 146-19-100 of the Department of Transportation Dangerous Cargoes Regulations (46 CFR 146-149), as amended.
2.(b)
The packaging and contents described in item 5 below, meets the safety standards set forth in Subpart C of Title 10, Code of Federal Regulatons, Part 71, " Packaging of Radioactive Materials for Transport and Transportation of Radioactive Material Under Certain Conditions.**
2.(c)
This certificate does not relieve the consignor from compliance with any requirement of the regulations of the U.S. Department of Transportation or other applicable regulatory agencies, including the government of any country through or into which the package will be transported.
- 3. This certificate is issued on the basis of a safety analysis report of the package design or application-3.(a)
Prepared by (Name and address):
3.(b)
Title and identification of report or application:
Nuclear Packaging, Incorporated Nuclear Packaging, Incorporated, application 1733 South Fawcett dated March 6,1978, as supplemented.
Tacoma, Washington 98402 3.(c) oocket No. 71-9111 4.
CONDITIONS This certificate is conditional upon the fulfilling of the requirements of Subpart D of 10 CFR 71, as applicabk, and the conditions specifi in item 5 below.
- 5. Description of Packaging and Authorized Contents, Model Number, Fissile Class, Other Conditions, and
References:
(a) Packaging (1) Model No.: CN6-80A (2) Description A steel encased, lead shielded cask for solid radioactive material meeting the requirements for low specific activity radioactive material. The overall dimensions of the cask are 70-1/2-inch
' diameter by 78-5/8-inch height. The cask consists of two concentric carbon steel cylindrical shells surrounding a 4-1/4-inch thick lead s hiel d..
The 3/8-inch thick inner shell has a 59-inch I.D., and the 1-inch thick outer shell has a 70-1/2-inch 0.D.; the base consists of 4-inch thick welded steel plates of 60-inch diameter and 70-1/2-inch diameter, and a stepped welded lid comprised of two 4-inch thick steel plates containing a centered 29-inch diameter secondary lid of similar construction with an additional 1-inch thick upper plate. The containment cavity is 59-inch diameter by 58-inches high.
Closure of the primary lid is accomplished by eight,1-1/4-inch bolts.
Both lids are sealed using silicone gaskets bonded to the lid plates. The secondary lid has a redundant neoprene seal.
A plugged drain port is located at the cask bottom. T.he cask is lined with 12 gauge stainless steel. Three lift lugs, located on the 1795 128 8001249 l
Page 2 - Certificate No. 9111 - Revision No. 3 - Docket No. 71-9111 5.
(a)
(2) Packaging Description (Continued) secondary lid are used for lifting both the cask and the primary lid. Four lugs, welded to the outer shell are used for tie-down.
The package gross weight is approximately 51,500 pounds.
(3) Drawing The packaging is fabricated in accordance with Nuclear Packaging, Incorporated Drawing No. BC-20-200D, Sheets 1 and 2 of 2, Revision C.
(b) Contents (1) Type and form of material (i) Greater than Type A quantities of byproduct material contained in solids and solidified waste, meeting the requirements for low specific c:tivity radioactive materials as defined in 10 CFR 571.4(g), in secondary containers.
(ii) Greater than Type A quantities of byproduct material contained in activated solid components meeting the requirements for low special activity radioactive material as defined in 10 CFR 571.4(g).
(2) Maximum quantity of material per package Greater than Type A quantities of radioactive material with the weight of the contents, secondary containers and shoring not exceeding 7,500 pounds. The decay heat load shall not exceed 400 watts.
6.
Shoring shall be provided in the shipping cask cavity sufficient to prevent significant movement of the contents or secondary containers relative to the outer packaging under normal conditions of transport.
7.
The drain line should be plugged and sealed prior to transport.
8.
The package authorized by this certificate shall be transported on a motor vehicle, railroad car, aircraft, inland water craft, or hold or deck of a seagoing vessel assigned for sole use of the licensee.
9.
The package authorized by this certificate is hereby approved for use under the general license provisions of 10 CFR 571.12(b).
- 10. Expiration dated: July 31,1983.
1795 129
f Page 3 - Certificate No. 9111 - Revision No. 3 - Docket No. 71-9111 REFERENCES Nuclear Packaging, Incorporated application dated March 6,1978.
Supplements dated: June 7 and 28,1978.
Chem-Nuclear Systems, Inc. Supplement dated June 29, 1979.
FOR THE U.S. NUCLEAR REGULATORY COMMISSION
)g Charles E. MacDdnald, Chief f
Transportation Certification Branch Division of Fuel Cycle and Material Safety JAN 0 31960 Date:
1795 130