LR-N12-0067, License Amendment Request to Correct Technical Specification and Facility Operating License Editorial Items
SBK-L-10097, License Amendment Request 10-03
RA-20-0012, License Amendment Request to Revise Technical Specifications Related to Accident Monitoring Instrumentation, Refueling Operations Instrumentation, and Electrical Equipment Protective Devices
RA-20-0178, Supplement to License Amendment Request to Revise Technical Specifications Related to Accident Monitoring Instrumentation, Refueling Operations Instrumentation, and Electrical Equipment Protective Devices
NRC-87-0175, Application for Amend to License NPF-43,deleting Four Circuits from Tech Spec 3/4.8.4.1, Electrical Equipment Protective Devices,Ac Circuits Inside Primary Containment. Fee Paid
ST-HL-AE-5000, Application for Amends to Licenses NPF-76 & NPF-80, Relocating TS 3.3.3.7 & 3.8.4.1 to Technical Requirements Manual
RBG-41056, Provides Clarifications to LAR 91-11 Re Removal of Component Lists
RBG-39894, Application for Amend to License NPF-47,revising TS for Removal of Component Lists,Per Generic Ltrs 91-01 & 91-08
W3P88-1843, Responds to NRC Ltr Re Violations & Deviations Noted in Insp Rept 50-382/88-21.Policy Amended to Allow Correspondence to NRC for Commitment Extension to Be Signed Based on Verbal Concurrence Rather than More Detailed Review Process
W3P88-1286, Application for Amend to License NPF-38,deleting motor-operated Valve Actuator compartment-heater Circuit Breakers from Table 3.8-1.Fee Paid
PY-CEI-NRR-0549, Proposed Tech Specs,Increasing Number of Instruments Used to Determine Drywell Average Air Temp,Deleting Requirement to Specificially Include Organizational Charts in Tech Specs & Correcting Listing of Breaker as OR25-S153-CB13
PY-CEI-NRR-0848, Application for Amend to License NPF-58,revising Tech Spec Table 3.8.4.1-1 to Delete Circuit Breakers from Table That Are Not Containment Penetration Conductor Overcurrent Protection Devices.Fee Paid
NRC-99-0072, Application for Amend to License NPF-43,revising SRs & Bases for Div I Battery Sys to Agree with Design of New Battery Replacement
05000498/LER-1989-002, :on 890106,discovered That Containment Electrical Penetrations Not Provided W/Backup Overcurrent Protection.Caused by Design Errors.Backup Protective Devices to Be Installed on Circuits.Part 21 Related
05000395/LER-1999-001, :on 990311,missed Surveillance Test for Electrical Equipment Protective Devices Was Noted.Caused by Inadequate Surveillance Tps.Fire Watches Were Posted Per TS 3.8.4.3 LCO Requirements.With
05000529/LER-1986-013-01, :on 860324,no Initial Surveillance Testing Performed for Two Containment Penetration Conductor Overcurrent Protective Devices.Caused by Personnel Error. Devices Tested
05000423/LER-1999-005-01, :on 990510,failure to Perform Surveillance on RCS Pressurizer Heater Penetration Breakers Was Noted.Caused by Lack of Mgt Support.Required Surveillance of Identified Ten Breakers Was Completed
05000423/LER-1986-007, :on 860202,limiting Condition for Operation & Action Statement for Tech Spec 3.8.4.1 Not Met.Caused by Failure to Adequately Track Weekly Surveillance Requirement. Action Statement Added to Dept Tracking Sys
05000423/LER-1996-051-01, :on 961221,TS Requirements for Application of 25% Surveillance Interval Extension of SR 4.0.2 to LCO Action Statements Misinterpreted.Caused by Incorrect Application of TS 4.0.2.Practice Discontinued
05000382/LER-1995-006-04, :on 951207,failed to Provide Backup Overcurrent Protection Due to Personnel Error.Installed Backup Overcurrent Protection for Circuits & Tested Two Breakers
05000458/LER-1995-006-02, :on 950627,identified Electrical Containment Penetration Overcurrent Protection Device Not Adequately Tested Due to Inadequate Development & Implementation of Historic Mod request.ENG-3-033 Revised
05000443/LER-1991-005, :on 910529,discovered That Circuit Breaker Feeding Rod Control Cluster Change Fixture Unlocked Since 910514.Caused by Personnel Error.Breaker Immediately Padlocked & Design Change Initiated
05000482/LER-1995-002, :on 950509,determined That Containment Penetration Breaker NG02BAR131 Not Tested Per TS Requirements Due to Omission of Breaker from Surveillance Tp.Surveillance Tp STS MT-024 Revised
05000353/LER-1991-001, :on 910107,primary Containment Penetration Conductor Overcurrent Protective Device Not Calibr Per TS & Surveillance Test Not Performed.Caused by Incorrect Review of Work on 901203.Procedure Revised
05000498/LER-1993-021, :on 930929,determined That Penetration Backup Fuse 15A Not Wired in Circuit as Required Due to Improper Rewiring of Circuits.Svc Request Disposition to Rework Wiring Per Applicable Design Documents
05000443/LER-1990-019, :on 900721,discovered That Time Limitation of Tech Spec 3.8.4.1 Exceeded by Nearly 7 H.Caused by Personnel Failure to Follow Procedures.Root Cause Analysis & Enhancement Sys Evaluation Initiated
05000443/LER-1993-005, :on 930318,two Accumulator Isolation Valves & Selected ECCS Valves Had Power Restored to Operator While Performing Miscellaneous Valve Stroke Surveillance.Caused by Personnel Error.Mccs E522 & E622 Deenergized
05000400/LER-1990-008, :on 900314,discrepancy in Amperage Rating of Circuit Breaker Providing Overcurrent Protection for Containment Penetration Conductor Discovered.Caused by Use of Oversized Breaker.Breaker Upsized
05000528/LER-1994-001, :on 940407,determined That SR 4.8.4.1 Not Fully Met Due to Personnel Error.Pm Task Specifying Sample Sizes of Molded Case Circuit Breakers Will Be Updated & Applicable Breakers Will Be Tested by 941014
05000529/LER-1995-004-01, :on 950706,identified Four Occassions Between 950407 & 0630 When Conditional Surveillance in TS LCO 3.8.4.1 Action a Not Performed Due to Inattention to Detail. CR Copy of Temporary Procedure 40TP-9ZZ04 Corrected
05000528/LER-1995-004, :on 950329,containment Electrical Penetration Overcurrent Protective Devices Found Outside Design Basis. Caused by Error on Part of Original Architect Engineer. Modified Affected Circuits Critical to Normal Operational
GO2-93-256, Application for Amend to License NPF-21,revising TS to Relocate Component Lists in Accordance W/Gl 91-08 & Selected Implementation of Commission Policy Statement of TS Improvements
05000397/LER-1993-014, :on 930803,discovered Inadequate Backup Overcurrent Protection for Containment Penetrations Due to Inadequate Design Analysis Using Inaccurate & Incomplete Documentation.Changed Plant Procedure
05000397/LER-1992-036, :on 920719,primary Containment Lighting Circuit Not Deenergized as Required by Tech Specs.Caused by Technical Inaccuracy in Procedure for Plant Startup.Plant Startup Procedures & Drywell Entry Revised
05000354/LER-2006-005, Drywell Hoist Breaker Not Open Prior to Operational Condition 2 Entry
05000382/LER-2004-004, Failure to Adequately Size Containment Electrical Penetration Over-Current Protection Devices Due to Latent Personnel Error
05000382/LER-2004-001, Regarding Failure to Provide Backup Over-Current Protection Due to Personnel Error
RA-20-0287, Response to Request for Additional Information Regarding License Amendment Request to Revise Technical Specifications Related to Accident Monitoring Instrumentation, Refueling Operations Instrumentation, and Electrical Equipment Protectiv